Re: [hylafax-users] Faxes being sent, but are not recieved or blank

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

Taras W. Rudko wrote:

> The following is returned from the Digi AccelePort RAS 4 card:
>
> FaxGetty[9038]: MODEM V80006691_M2-K56_DS Digi RAS modem 56000
>
> Were V80006691 should be the firmware rev.
>
>  
>
> I have set the server up and am able to receive faxes without 
> difficultly, however when I attempt to send a fax the receiver picks 
> up and prints either nothing or blank pages.  The following is a copy 
> of the config file for the device followed by a log from a 
> transaction.  Any assistance in resolving this would be greatly 
> appreciated.

> Jun 15 15:00:00.36: [13653]: USE 2-D MMR
>
> Jun 15 15:00:00.36: [13653]: USE 0 ms/scanline
>
> Jun 15 15:00:00.36: [13653]: <-- [23:AT+FIS=1,5,0,2,3,1,0,0\r]
>
> Jun 15 15:00:00.54: [13653]: --> [2:OK]
>
> Jun 15 15:00:00.54: [13653]: <-- [7:AT+FDT\r]
>
> Jun 15 15:00:07.88: [13653]: --> [20:+FCS:1,5,0,2,3,1,0,0]
>
> Jun 15 15:00:07.91: [13653]: --> [7:CONNECT]


The Digi Class 2.0 is very problematic.  In this case it's possibly a 
problem with the firmware breaking on MMR (as it did in the past with 
receiving).  You may want to try putting this in your config file:

Class2DCCQueryCmd: "!(0-1),(0-5),(0-2),(0-2),(0-1),(0-1),0,(0-7)"

Lee.


____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*