[hylafax-users] Aboute USRobotics courier 56K Business

["Christian CJ. Jonasson" <Christian.Jonasson@xxxxxxxxx>]

Hi

I have smal problem with faxstat showing

Modem ttyS1 (0000000000000000): Waiting for modem to come ready

 

I am using that modem only to send fax and that is no problem

But I think in narrow time frame I must fix it to get fax.

So my quest is how can I fix it to show correct faxstat and is that some special compatibility problem with USRobotics courier 56K Business?

 

ModemType:                         Class1                                  # use class 1 interface

ModemRate:                         38400

ModemFlowControl:               xonxoff                                 # software flow control

#

ModemSetupDTRCmd:          ATS13=1&D2  # setup so DTR drop resets modem

ModemSetupDCDCmd:          AT&C1                                 # setup so DCD reflects carrier (or not)

ModemNoFlowCmd:                                    AT&H0&I0&R1 # setup modem for no flow control

ModemHardFlowCmd:            AT&H1&I0&R2 # setup modem for hardware flow control

ModemSoftFlowCmd:             AT&H2&I2&R1 # setup modem for software flow control

ModemResultCodesCmd:       ATQ0X4                                # enable result codes

#

ModemMfrQueryCmd:            !USR

ModemModelQueryCmd:        ATI3

ModemRevQueryCmd:           ATI7                                     # XXX returns a multi-line result

#

# When AT+FCLASS=1 is issued the modem automatically switches

# to software flow control; these parameters let the fax software

# reset flow control as needed after entering Class 1.

#

Class1NFLOCmd:                                       AT&H0&I0&R1 # setup modem for no flow control

Class1HFLOCmd:                                       AT&H1&I0&R2 # setup modem for hardware flow control

Class1SFLOCmd:                                       ""                                         # modem does this automatically

#

# This should resolve "DIS/DTC received 3 times" errors:

#

Class1ResponseWaitCmd:     AT+FRS=1      # wait after sending TCF for response

#

# The remainder of this configuration is included so that the

# modem "idles" in Class 0 while not sending or receiving facsimile.

#

ModemSetupAACmd:            AT+FCLASS=0                     # leave modem idling in class 0

ModemAnswerCmd:                                    AT+FCLASS=1A                   # answer in Class 1

#

# When using AT+FRS=n we see USR modems reset themselves in the middle of sessions

# this is not good.  So, we seem to work-around that problem by not using the

# command.  Unfortunately, this isn't an ideal thing.

#

Class1SwitchingCmd:            "<delay\0727>"