[hylafax-users] No fax transmission after complete negotiation!

[Kib Eki <kibeki@xxxxxxx>]

Hi,

am not able to send any faxes.

Faxreceiving works fine!

Does anybody has got similar experiences?

Thanks,
Kib

    ---- Transcript of session follows ----

Mar 24 14:11:22.26: [ 4530]: SESSION BEGIN 000000048 XXXX
Mar 24 14:11:22.26: [ 4530]: HylaFAX (tm) Version 4.2.1
Mar 24 14:11:22.26: [ 4530]: MODEM input buffering enabled
Mar 24 14:11:22.66: [ 4530]: DIAL xxxx
Mar 24 14:11:33.58: [ 4530]: REMOTE CSI "XXXX"
Mar 24 14:11:33.58: [ 4530]: REMOTE best rate 14400 bit/s
Mar 24 14:11:33.58: [ 4530]: REMOTE max A4 page width (215 mm)
Mar 24 14:11:33.58: [ 4530]: REMOTE max unlimited page length
Mar 24 14:11:33.58: [ 4530]: REMOTE best vres 3.85 line/mm
Mar 24 14:11:33.58: [ 4530]: REMOTE best format 1-D MH
Mar 24 14:11:33.58: [ 4530]: REMOTE supports T.30 Annex C, half duplex ECM
Mar 24 14:11:33.58: [ 4530]: REMOTE best 0 ms/scanline
Mar 24 14:11:33.58: [ 4530]: USE 14400 bit/s
Mar 24 14:11:33.58: [ 4530]: USE error correction mode
Mar 24 14:11:33.58: [ 4530]: USE 0 ms/scanline
Mar 24 14:11:33.68: [ 4530]: MODEM set DTR OFF
Mar 24 14:11:33.68: [ 4530]: SESSION END

    ---- Unsent job status ----



____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*