HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [hylafax-users] MODEM Command error



Hi Sebastian

Faxgetty is not running as I am using a send only setup.

I have been browsing through the archives, and I have seen some of the solutions given to errors that I am getting are to setup the modem as a class1 modem. I have set up my 'U.S. ROBOTICS 56K FAX EXT REV. 11.11.13 5601' modem as a class 2.0, could this have anything to do with it....
If I run cu -l ttyS0 and then at+fclass=?
I get 0,1,2.0 ??? so I just assumed that 2.0 would be fine, what is best?


Sebastian Flothow wrote:

Am 7. Jul 2004 um 16:28 Uhr schrieb Clinton Bosch:

And from then on ALL subsequent faxes fail with the same error. I have found that by running the command, it seems to come right again: /usr/local/sbin/faxmodem -c '(0,1),(0-5),(0-2),(0-2),0,0,0,(0-7)' ttyS0

But why do I need to "Remind" hylafax about its modem all the time???


Is faxgetty running? It should monitor the modem for any interesting events and notify the main (queueing) daemon.


Sebastian



-- Clinton Bosch - Hemisphere Technologies JDO Genie - High performance JDO for JDBC http://www.hemtech.co.za Tel +27 21 670 3940 - Fax +27 21 670 3979 Cell +27 82 805 9479


____________________ HylaFAX(tm) Users Mailing List _______________________ To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*




Project hosted by iFAX Solutions