RE: Modem ZyXEL Elite 2864 ID

[Alexandre Meissonnier <ameissonnier@dohle.com>]

-----Original Message-----
From:	Matthias.Apitz@softcon.de [SMTP:Matthias.Apitz@softcon.de]
Sent:	Wednesday, June 18, 1997 8:59 AM
To:	Alexandre Meissonnier
Cc:	flexfax@sgi.com
Subject:	Re: Modem ZyXEL Elite 2864 ID

Alexandre Meissonnier wrote:
    
    Hi all,
    
>     I have problems configuring my Elite 2864 ID modem for HylaFAX. This is =
>     one of ZyXEL's new ISDN modems and it is connected to an ISDN plug.
> 
> I'm using my Elite 2864I (DSS1) for many month (>>18) with
> HylaFAX and it works very reliable. I'm running an older
> firmware version:
> ati1
> Elite 2864I DSS1: v1.09
> Internal fax/modem :  V Z95901A+
   
Mine is: Elite 2864ID DSS1 v1.142864
	 
I have tested a little more and isolated 2 problems:

1) (probably not related to the modem): I have 2 modems, one 1496 which works fine and the 2864. Both are connected to a serial port with faxgetty running on it, and I have reset the modem priorities with "faxmodem -u 255 tty[1/2]A. But HylaFAX always ignores the 2nd modem. No matter which modem is connected to which port, all faxes will always go to tty1A. 

2) When I force HylaFAX to send via the new modem with "faxsend -m tty2A" I get this result: 

Jun 18 13:16:01 idefix2 FaxSend[825]: DELAY 2600 ms
Jun 18 13:16:04 idefix2 FaxSend[825]: <-- [36:AT&B1&N0&S0S18=4S38.3=1E0V1Q0S0=H
0\r]
Jun 18 13:16:09 idefix2 FaxSend[825]: MODEM <Timeout>
[repeated several times until "Modem wedged" message]

When I connect to the modem with cu and enter the same command string, I get an "OK" at once. Where's the difference???

Thanks for any help

	Alexandre

--
Alexandre Meissonnier
Dohle Handelsgruppe Systemberatung GmbH
53719 Siegburg (Germany)
ameissonnier@dohle.com