User talk:Biss65

  Hello!

My modem is Agere OCM V.92 Ver2.7a (Jun 14 2004) Voice Mercury DP2SH mode-ii SERIAL. Its configuration is:

Option               Selection       AT Cmd
   ---------------      ------------    --------
   Comm Standard        CCITT           B
   CommandCharEcho      Enabled         E
   Speaker Volume       Medium          L
   Speaker Control      OnUntilCarrier  M
   Result Codes         Disabled        Q
   Dialer Type          Tone            T/P
   ResultCode Form      Number          V
   ExtendResultCode     Enabled         X
   DialTone Detect      Enabled         X
   BusyTone Detect      Enabled         X
   LSD Action           Standard RS232  &C
   DTR Action           Standard RS232  &D
   V22b Guard Tone      1800 Hz         &G
   Flow Control         Software        &K
   Error Control Mode   V42,MNP,Buffer  \N
   Data Compression     V44 V42bis MNP5 %C
   AutoAnswerRing#      1               S0
   AT Escape Char       43              S2
   CarriageReturn Char  13              S3
   Linefeed Char        10              S4
   Backspace Char       8               S5
   Blind Dial Pause     4 sec           S6
   NoAnswer Timeout     60 sec          S7
   "," Pause Time       4 sec           S8
   No Carrier Disc      2000 msec       S10
   DTMF Dial Speed      90 msec         S11
   Escape GuardTime     1000 msec       S12
   Data Calling Tone    Enabled         S35
   Line Rate            4800            S37
   Stored Phone Numbers

   My problem is that I can not configure the data format 7E1, flow control software, line speed 4800 bps. Im using comands ATS37=7, ATS13=1&D2,but does not work correctly. When transmitting data between two modems over the PSTN, connected to the terminals working with data format 7E1 observed errors.

Please, help! Regards