Re: [hylafax-users] modem config for apple USB modem

[Yoshi <ml@xxxxxxxxxxxxxxxx>]

Hello

On 2007/10/13, at 2:20, Lee Howard wrote:

> Yoshi wrote:
>
> > Oct 12 10:56:55.17: [   86]: SESSION BEGIN 000000013 ***********
> > Oct 12 10:56:55.17: [   86]: HylaFAX (tm) Version 4.4.0
> > Oct 12 10:56:55.17: [   86]: <-- [4:ATA\r]
> > Oct 12 10:57:02.43: [   86]: --> [7:CONNECT]
> > Oct 12 10:57:06.46: [   86]: --> [5:ERROR]
> > Oct 12 10:57:06.46: [   86]: MODEM Command error
> > Oct 12 10:57:06.46: [   86]: ANSWER:
> > Oct 12 10:57:06.46: [   86]: SESSION END
>
>
> The *only* case in which ATA should result in error would be if,  
> according to T.31...
>
> "if five seconds elapses from the time when the DCE reported the  
> CONNECT result code without any additional data transmitted from  
> the DTE"
>
> This would require a HylaFAX problem.  Your logging level is not  
> sufficient to see if it is HylaFAX at fault here.  Please set  
> ServerTracing to 0xFFF immediately preceded by "TracingMask: 0" in  
> your modem config file, restart faxgetty, and try again.  Then show  
> me the session log.
>
> Thanks,
>
> Lee.

I tried AT commands written on modem config file on 'minicom',
there occured an error by:
AT+FAA=1

It was declared as:
ModemSetupAACmd:       AT+FAA=1

So I commented out that and call to mac, but log has not changed.

Umm...

(modem config: config.tty.usbmodem)
ModemType:              Class1          # use class 1 interface
ModemRate:              19200           # locked for fax  
sending&receiving
ModemFlowControl:       rtscts          # default
ModemNoFlowCmd:         AT\Q            # disable flow control cmd
ModemSoftFlowCmd:       AT&R1\Q1        # software flow control cmd
ModemHardFlowCmd:       AT&R\Q3         # hardware flow control cmd
ModemSetupDTRCmd:       AT&D3           # DTR off causes modem to reset
ModemSetupDCDCmd:       AT&C1           # DCD follows carrier
ModemSetupAACmd:        AT+FAA=1
ModemAnswerCmd:         "ATA\r"
ModemWaitForConnect:   yes             # modem sends FAX/DATA first
ModemAnswerDataBeginCmd:"ATO\n<waitfor\072CONNECT>"
ModemMfrQueryCmd:       !Motorola
ModemModelQueryCmd:     !28.8
ModemRevQueryCmd:       AT%V            # model and firmware rev
ModemDialCmd:           ATDT%s          # T for tone dialing


Yoshi


____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*