[hylafax-users] My new Log! Re: No Sending / Receiving Possible With Devolo FUN II Modem CLASS 1]

[NeroZero <support4fpo@xxxxxxx>]

Here my log:
> Your job to 555 failed because:
>
> Failure to train remote modem at 2400 bps or minimum speed; Giving up
> after 3 attempts to send same page
>
>
>     ---- Transcript of session follows ----
>
> Feb 09 01:54:26.09: [21287]: SESSION BEGIN 000000021 14157674
> Feb 09 01:54:26.09: [21287]: HylaFAX (tm) Version 4.3.1
> Feb 09 01:54:26.09: [21287]: SEND FAX: JOB 6 DEST 555 COMMID 000000021
> DEVICE '/dev/ttyS0' FROM 'dau <dau@xxxxxxxx>' USER dau
> Feb 09 01:54:26.09: [21287]: <-- [12:AT+FCLASS=1\r]
> Feb 09 01:54:26.12: [21287]: --> [2:OK]
> Feb 09 01:54:26.12: [21287]: DIAL 7674
> Feb 09 01:54:26.12: [21287]: <-- [11:ATDT0W555\r]
> Feb 09 01:54:49.59: [21287]: --> [7:CONNECT]
> Feb 09 01:54:51.09: [21287]: --> [2:OK]
> Feb 09 01:54:51.09: [21287]: REMOTE NSF "50 80 00 16 00 00 02 00 00 00
> 00 00 00 00 00 00 00 00 00 FF"
> Feb 09 01:54:51.09: [21287]: NSF remote fax equipment: unknown
> Feb 09 01:54:51.09: [21287]: <-- [9:AT+FRH=3\r]
> Feb 09 01:54:51.10: [21287]: --> [7:CONNECT]
> Feb 09 01:54:51.78: [21287]: --> [2:OK]
> Feb 09 01:54:51.78: [21287]: REMOTE CSI ""
> Feb 09 01:54:51.78: [21287]: <-- [9:AT+FRH=3\r]
> Feb 09 01:54:51.79: [21287]: --> [7:CONNECT]
> Feb 09 01:54:52.01: [21287]: --> [2:OK]
> Feb 09 01:54:52.01: [21287]: REMOTE best rate 9600 bit/s
> Feb 09 01:54:52.01: [21287]: REMOTE max A4 page width (215 mm)
> Feb 09 01:54:52.01: [21287]: REMOTE max unlimited page length
> Feb 09 01:54:52.01: [21287]: REMOTE best vres 7.7 line/mm
> Feb 09 01:54:52.01: [21287]: REMOTE format support: MH, MR
> Feb 09 01:54:52.01: [21287]: REMOTE best 20 ms, 10 ms/scanline
> Feb 09 01:54:52.01: [21287]: USE 9600 bit/s
> Feb 09 01:54:52.01: [21287]: SEND file "docq/cover6;c1"
> Feb 09 01:54:52.01: [21287]: USE A4 page width (215 mm)
> Feb 09 01:54:52.01: [21287]: USE unlimited page length
> Feb 09 01:54:52.01: [21287]: USE 7.7 line/mm
> Feb 09 01:54:52.01: [21287]: USE 2-D MR
> Feb 09 01:54:52.01: [21287]: USE 10 ms/scanline
> Feb 09 01:54:52.01: [21287]: SEND training at v.29 9600 bit/s
> Feb 09 01:54:52.01: [21287]: <-- [9:AT+FRS=7\r]
> Feb 09 01:55:22.02: [21287]: MODEM <Timeout>
> Feb 09 01:55:22.02: [21287]: Failure to receive silence.
> Feb 09 01:55:22.02: [21287]: Error sending T.30 prologue frames
> Feb 09 01:55:22.02: [21287]: SEND training at v.29 7200 bit/s
> Feb 09 01:55:22.02: [21287]: <-- [9:AT+FRS=7\r]
> Feb 09 01:55:22.04: [21287]: --> [2:OK]
> Feb 09 01:55:22.04: [21287]: <-- [9:AT+FTH=3\r]
> Feb 09 01:55:22.11: [21287]: --> [7:CONNECT]
> Feb 09 01:55:23.10: [21287]: --> [7:CONNECT]
> Feb 09 01:55:24.13: [21287]: --> [2:OK]
> Feb 09 01:55:24.13: [21287]: <-- [9:AT+FTS=7\r]
> Feb 09 01:55:24.21: [21287]: --> [2:OK]
> Feb 09 01:55:24.21: [21287]: <-- [10:AT+FTM=72\r]
> Feb 09 01:55:24.51: [21287]: --> [7:CONNECT]
> Feb 09 01:55:26.32: [21287]: --> [2:OK]
> Feb 09 01:55:26.32: [21287]: <-- [9:AT+FRH=3\r]
> Feb 09 01:55:26.85: [21287]: --> [7:CONNECT]
> Feb 09 01:55:26.90: [21287]: --> [5:ERROR]
> Feb 09 01:55:26.90: [21287]: MODEM Command error
> Feb 09 01:55:26.90: [21287]: FCS error
> Feb 09 01:55:26.90: [21287]: <-- [9:AT+FRS=7\r]
> Feb 09 01:55:56.90: [21287]: MODEM <Timeout>
> Feb 09 01:55:56.90: [21287]: DELAY 1500 ms
> Feb 09 01:55:58.40: [21287]: SEND training at v.27ter 4800 bit/s
> Feb 09 01:55:58.40: [21287]: <-- [9:AT+FRS=7\r]
> Feb 09 01:55:58.43: [21287]: --> [2:OK]
> Feb 09 01:55:58.43: [21287]: <-- [9:AT+FTH=3\r]
> Feb 09 01:55:58.51: [21287]: --> [7:CONNECT]
> Feb 09 01:55:59.50: [21287]: --> [7:CONNECT]
> Feb 09 01:56:00.52: [21287]: --> [2:OK]
> Feb 09 01:56:00.52: [21287]: <-- [9:AT+FTS=7\r]
> Feb 09 01:56:00.60: [21287]: --> [2:OK]
> Feb 09 01:56:00.60: [21287]: <-- [10:AT+FTM=48\r]
> Feb 09 01:56:01.56: [21287]: --> [7:CONNECT]
> Feb 09 01:56:03.38: [21287]: --> [2:OK]
> Feb 09 01:56:03.38: [21287]: <-- [9:AT+FRH=3\r]
> Feb 09 01:56:06.48: [21287]: --> [0:]
> Feb 09 01:56:06.48: [21287]: MODEM <Empty line>
> Feb 09 01:56:06.49: [21287]: --> [2:OK]
> Feb 09 01:56:06.49: [21287]: DELAY 1500 ms
> Feb 09 01:56:07.99: [21287]: SEND training at v.27ter fallback mode
> 2400 bit/s
> Feb 09 01:56:07.99: [21287]: <-- [9:AT+FRS=7\r]
> Feb 09 01:56:08.74: [21287]: --> [2:OK]
> Feb 09 01:56:08.74: [21287]: <-- [9:AT+FTH=3\r]
> Feb 09 01:56:08.81: [21287]: --> [7:CONNECT]
> Feb 09 01:56:09.80: [21287]: --> [7:CONNECT]
> Feb 09 01:56:10.83: [21287]: --> [2:OK]
> Feb 09 01:56:10.83: [21287]: <-- [9:AT+FTS=7\r]
> Feb 09 01:56:10.91: [21287]: --> [2:OK]
> Feb 09 01:56:10.91: [21287]: <-- [10:AT+FTM=24\r]
> Feb 09 01:56:12.11: [21287]: --> [7:CONNECT]
> Feb 09 01:56:13.95: [21287]: --> [2:OK]
> Feb 09 01:56:13.95: [21287]: <-- [9:AT+FRH=3\r]
> Feb 09 01:56:17.07: [21287]: --> [0:]
> Feb 09 01:56:17.07: [21287]: MODEM <Empty line>
> Feb 09 01:56:17.09: [21287]: --> [2:OK]
> Feb 09 01:56:17.09: [21287]: DELAY 1500 ms
> Feb 09 01:56:18.59: [21287]: TRAINING failed
> Feb 09 01:56:18.59: [21287]: SEND: Failure to train remote modem at
> 2400 bps or minimum speed; Giving up after 3 attempts to send same
> page "docq/cover6;c1", dirnum 0
> Feb 09 01:56:18.59: [21287]: <-- [9:AT+FTH=3\r]
> Feb 09 01:56:18.66: [21287]: --> [7:CONNECT]
> Feb 09 01:56:19.90: [21287]: --> [2:OK]
> Feb 09 01:56:19.90: [21287]: <-- [5:ATH0\r]
> Feb 09 01:56:20.21: [21287]: --> [2:OK]
> Feb 09 01:56:20.21: [21287]: SESSION END
>
> ------- Unsent job status -------
>       Destination: 555
>             JobID: 6
>           GroupID: 6
>            Sender: dau
>          Mailaddr: dau@
>           CommID: 000000021
>             Modem: any
>    Submitted From: localhost
>        Page Width: 209  (mm)
>       Page Length: 296 (mm)
>        Resolution: 196 (lpi)
>            Status: Failure to train remote modem at 2400 bps or
> minimum speed; Giving up after 3 attempts to send same page
>           Dialogs: 3
>             Dials: 0
>             Calls: 3
>             Pages: 0
>          TotPages: 2
>          Attempts: 3
>            Dirnum:
>



darren.nickerson@xxxxxxxx wrote:
> Can you show me the bounce?
>
> -Darren
>
> ----- Original Message ----- From: "NeroZero" <support4fpo@xxxxxxx>
> To: <sales@xxxxxxxxxxx>
> Sent: Thursday, February 08, 2007 8:19 PM
> Subject: [Fwd: No Sending / Receiving Possible With Devolo FUN II
> Modem CLASS 1]
>
>
>> ??? My email to the list bounces? is there no more list?!?!?!?
>>
>


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*