Re: [hylafax-users] Unspecified Transmit Phase C error

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

SCIN - Danilo Bottino wrote:

> dic 12 09:27:09.90: [18823]: REMOTE best rate 33600 bit/s
> dic 12 09:27:09.90: [18823]: REMOTE max A4 page width (215 mm)
> dic 12 09:27:09.90: [18823]: REMOTE max unlimited page length
> dic 12 09:27:09.90: [18823]: REMOTE best vres 15.4 line/mm
> dic 12 09:27:09.90: [18823]: REMOTE format support: MH, MR, MMR, JBIG
> dic 12 09:27:09.90: [18823]: REMOTE supports T.30 Annex A, 256-byte ECM
> dic 12 09:27:09.90: [18823]: REMOTE best 10 ms/scanline
> dic 12 09:27:09.90: [18823]: USE 9600 bit/s


First off, why is your modem not attempting V.17, at least?  Have you 
deliberately disabled V.17 use?

> dic 12 09:27:21.07: [18823]: SEND training at v.27ter 4800 bit/s


Secondly, the fact that we had to retrain down to V.27ter 4800 seems to 
indicate line trouble ... or at least an incompatibility with the V.29 
modulators (however, those seemed to have been fine up until now).

> dic 12 09:27:27.55: [18823]: <-- [10:AT+FTMH\r]
> dic 12 09:27:27.56: [18823]: --> [7:CONNECT]
> dic 12 09:27:27.56: [18823]: DELAY 400 ms
> dic 12 09:29:55.05: [18823]: MODEM WRITE SHORT: sent 1026, wrote 581
> dic 12 09:29:55.05: [18823]: SEND end page
> dic 12 09:29:55.05: [18823]: Unspecified Transmit Phase C error 


Here the modem crashed while transferring the data.  This could possibly 
be because it recognized a hangup by the receiver... or it could be a 
modem bug... or a serial driver bug.

Lee.

____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*