[hylafax-users] Missing EOL after 5 seconds (section 3.2/T.4)

[Wolfgang.Fuertbauer@xxxxxxxxx]

Hi all,
many faxes are not received with the
following errorcode:

Feb 09 10:40:05.51: [21823]: REMOTE HANGUP: Missing
EOL after 5 seconds (section 3.2/T.4) (code 91)

who can help please ?
Best regards
Wolfgang Fürtbauer

Modem:

Feb  9 10:47:34 hylafax FaxGetty[30964]:
OPEN /dev/ttyC8  HylaFAX (tm) Version 4.2.0
Feb  9 10:47:45 hylafax FaxGetty[30964]:
MODEM ZYXEL Omni56K/1.01

Config:

CountryCode:          
     +43
AreaCode:                7665
FAXNumber:                +43-7665-8123-22
LongDistancePrefix:        0
InternationalPrefix:        0
DialStringRules:        etc/dialrules
ServerTracing:              
 1
SessionTracing:              
 11
RecvFileMode:              
 0600
LogFileMode:                0600
DeviceMode:                0600
RingsBeforeAnswer:        1
SpeakerVolume:              
 off
GettyArgs:                "-h
%l dx_%s"
LocalIdentifier:        "EBEWE Pharma"
TagLineFont:                etc/lutRS18.pcf
TagLineFormat:              
 "From %%l|%c|Page %%P of %%T"
NoCarrierRetrys:        3
MaxRecvPages:              
 80
Class2RecvDataTrigger:        ``"\022"''
               #
a la 2388-B
Class2XmitWaitForXON:   yes            
# if true, wait for XON before send
#
# Configuration parameters for Class 2 modems.
#
Class2Cmd:                AT+FCLASS=2
       # command to enter class 2
Class2BORCmd:              
 AT+FBOR=0        # bit order
for phase B/C/D (direct)
Class2RELCmd:              
 AT+FREL=1        # byte-align
EOL codes on recv
Class2CQCmd:                ""
               #
commands to enable copy quality proc.
Class2AbortCmd:              
 AT+FK              
 # abort session command
Class2CQQueryCmd:        AT+FCQ=?    
   # query for copy quality capabilities
Class2DCCQueryCmd:        AT+FDCC=?  
     # query for modem capabilities
Class2TBCCmd:              
 AT+FTBC=0        # setup stream
mode
Class2CRCmd:                AT+FCR=1
       # enable capability to receive
Class2PHCTOCmd:              
 AT+FPHCTO=30        # set phase
C timeout parameter
Class2BUGCmd:              
 AT+FBUG=1        # enable HDLC
frame tracing
Class2LIDCmd:              
 AT+FLID            
   # set local identifier command
Class2DCCCmd:              
 AT+FDCC            
   # set modem capabilities command
Class2DISCmd:              
 AT+FDIS            
   # set session parameters command
Class2DDISCmd:              
 ""            
   # disable pre-dial DIS command hack
Class2CIGCmd:              
 AT+FCIG            
   # set polling identifier command
Class2PTSCmd:              
 AT+FPTS            
   # set post-page status command
Class2SPLCmd:              
 AT+FSPL            
   # set polling indicator command
#
# If Class2RecvDataTrigger is not set, then it is set to DC1
#
#Class2RecvDataTrigger:        ""
               #
character sent to modem to start recv
#Class2XmitWaitForXON:        yes    
           # if true, wait
for XON before send

Log:

Feb 09 10:38:49.75: [21823]: SESSION BEGIN 000019343
437665812311
Feb 09 10:38:49.75: [21823]: HylaFAX (tm) Version 4.2.0
Feb 09 10:38:49.75: [21823]: <-- [4:ATA\r]
Feb 09 10:38:59.60: [21823]: --> [5:+FCON]
Feb 09 10:38:59.60: [21823]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyC8'
Feb 09 10:38:59.60: [21823]: RECV FAX: begin
Feb 09 10:38:59.60: [21823]: RECV FAX: CDPN
Feb 09 10:38:59.85: [21823]: --> [28:+FTSI:"      
  06181354302"]
Feb 09 10:38:59.85: [21823]: REMOTE TSI "06181354302"
Feb 09 10:38:59.85: [21823]: --> [21:+FDCS:0,5,0,2,1,0,0,1]
Feb 09 10:38:59.85: [21823]: REMOTE wants 14400 bit/s
Feb 09 10:38:59.85: [21823]: REMOTE wants A4 page width (215 mm)
Feb 09 10:38:59.85: [21823]: REMOTE wants unlimited page length
Feb 09 10:38:59.85: [21823]: REMOTE wants 3.85 line/mm
Feb 09 10:38:59.85: [21823]: REMOTE wants 2-D MR
Feb 09 10:38:59.85: [21823]: --> [2:OK]
Feb 09 10:38:59.85: [21823]: <-- [7:AT+FDR\r]
Feb 09 10:39:04.17: [21823]: --> [5:+FCFR]
Feb 09 10:39:05.13: [21823]: --> [21:+FDCS:0,5,0,2,1,0,0,1]
Feb 09 10:39:05.13: [21823]: REMOTE wants 14400 bit/s
Feb 09 10:39:05.13: [21823]: REMOTE wants A4 page width (215 mm)
Feb 09 10:39:05.13: [21823]: REMOTE wants unlimited page length
Feb 09 10:39:05.13: [21823]: REMOTE wants 3.85 line/mm
Feb 09 10:39:05.13: [21823]: REMOTE wants 2-D MR
Feb 09 10:39:05.13: [21823]: --> [7:CONNECT]
Feb 09 10:39:05.13: [21823]: RECV: begin page
Feb 09 10:39:05.13: [21823]: RECV: send trigger 0140
Feb 09 10:39:05.13: [21823]: Copy quality checking performed by host
Feb 09 10:40:05.51: [21823]: RECV: Missing EOL after 5 seconds
Feb 09 10:40:05.51: [21823]: REMOTE HANGUP: Missing EOL after 5 seconds
(section 3.2/T.4) (code 91)
Feb 09 10:40:05.51: [21823]: RECV FAX (000019343): recvq/fax000013195.tif
from 06181354302, route to <unspecified>, 0 pages in 1:06
Feb 09 10:40:05.51: [21823]: RECV FAX: Missing EOL after 5 seconds (section
3.2/T.4)
Feb 09 10:40:05.51: [21823]: <-- [6:AT+FK\r]
Feb 09 10:40:35.51: [21823]: MODEM <Timeout>
Feb 09 10:40:35.51: [21823]: RECV FAX (000019343): session with 06181354302
terminated abnormally: Missing EOL after 5 seconds (section 3.2/T.4)
Feb 09 10:40:35.51: [21823]: RECV FAX: bin/faxrcvd "recvq/fax000013195.tif"
"ttyC8" "000019343" "Missing EOL after 5 seconds
(section 3.2/T.4)" "" "" ""
Feb 09 10:40:35.51: [21823]: RECV FAX: end
Feb 09 10:40:35.51: [21823]: SESSION END

----------------------------------------------------------------------
Wolfgang Fuertbauer (e-Mail: Wolfgang.Fuertbauer@xxxxxxxxx)
EBEWE Pharma                          
Mondseestrasse 11                     
4866  Unterach, Austria
Tel +43 7665 8123 315    Mobile: +43 664 8397987
Fax +43 7665 8123 1487
http://www.ebewe.com