[hylafax-users] Unspecified Phase D error

[Pablo Alcubilla <pablo.alcubilla@xxxxxxxxxxxxx>]

Hello,

  I'm having a problem with a Diva Server card when receiving faxes with 2 pages or more. I know the problem has shown in the past, but havent seen an specific reply, it always depends on hardware.

   Thanks in advance.

Pablo Alcubilla

-----------------------------------------------------
#cat /proc/net/isdn/eicon/divas
divas: 1.0beta8(1.1.2.6) 104-72(104-500)
1: Diva Server BRI-2M PCI         Serial:XXXX       IRQ:22
2: Diva Server BRI-2M PCI         Serial:XXXX       IRQ:18
-----------------------------------------------------
The full document was not received because:

   Unspecified Phase D error

   ---- Transcript of session follows ----

Jun 09 13:20:33.69: [ 1023]: SESSION BEGIN 000008289 34916596242
Jun 09 13:20:33.69: [ 1023]: HylaFAX (tm) Version 4.2.0beta1
Jun 09 13:20:33.69: [ 1023]: <-- [4:ATA\r]
Jun 09 13:20:45.84: [ 1023]: --> [5:+FCON]
Jun 09 13:20:45.84: [ 1023]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyds01'
Jun 09 13:20:45.84: [ 1023]: STATE CHANGE: ANSWERING -> RECEIVING
Jun 09 13:20:45.84: [ 1023]: MODEM input buffering enabled
Jun 09 13:20:45.84: [ 1023]: RECV FAX: begin
Jun 09 13:20:45.84: [ 1023]: --> [26:+FTSI:           IDENTIFICADOR]
Jun 09 13:20:45.84: [ 1023]: REMOTE TSI "IDENTIFICADOR"
Jun 09 13:20:45.84: [ 1023]: --> [22:+FDCS: 1,5,0,0,0,0,0,0]
Jun 09 13:20:45.84: [ 1023]: REMOTE wants 14400 bit/s
Jun 09 13:20:45.84: [ 1023]: REMOTE wants A4 page width (215 mm)
Jun 09 13:20:45.84: [ 1023]: REMOTE wants A4 page length (297 mm)
Jun 09 13:20:45.84: [ 1023]: REMOTE wants 7.7 line/mm
Jun 09 13:20:45.84: [ 1023]: REMOTE wants 1-D MH
Jun 09 13:20:45.84: [ 1023]: --> [2:OK]
Jun 09 13:20:45.84: [ 1023]: <-- [7:AT+FDR\r]
Jun 09 13:20:45.94: [ 1023]: --> [5:+FCFR]
Jun 09 13:20:45.94: [ 1023]: --> [22:+FDCS: 1,5,0,0,0,0,0,0]
Jun 09 13:20:45.94: [ 1023]: REMOTE wants 14400 bit/s
Jun 09 13:20:45.94: [ 1023]: REMOTE wants A4 page width (215 mm)
Jun 09 13:20:45.94: [ 1023]: REMOTE wants A4 page length (297 mm)
Jun 09 13:20:45.94: [ 1023]: REMOTE wants 7.7 line/mm
Jun 09 13:20:45.94: [ 1023]: REMOTE wants 1-D MH
Jun 09 13:20:45.94: [ 1023]: --> [7:CONNECT]
Jun 09 13:20:45.94: [ 1023]: RECV: begin page
Jun 09 13:20:45.94: [ 1023]: RECV: send trigger 021
Jun 09 13:20:45.94: [ 1023]: Copy quality checking performed by host
Jun 09 13:21:08.84: [ 1023]: RECV: 2155 total lines, 0 bad lines, 0 consecutive bad lines
Jun 09 13:21:08.84: [ 1023]: --> [13:+FPTS: 1,2156]
Jun 09 13:21:08.84: [ 1023]: --> [7:+FET: 0]
Jun 09 13:21:08.84: [ 1023]: RECV recv MPS (more pages, same document)
Jun 09 13:21:08.84: [ 1023]: --> [2:OK]
Jun 09 13:21:08.84: [ 1023]: RECV send MCF (message confirmation)
Jun 09 13:21:08.84: [ 1023]: RECV FAX (000008289): from IDENTIFICADOR, page 1 in 0:23, A4, 7.7 line/mm, 1-D MH, 14400 bit/s
Jun 09 13:21:08.84: [ 1023]: <-- [7:AT+FDR\r]
Jun 09 13:21:08.94: [ 1023]: --> [7:CONNECT]
Jun 09 13:21:08.94: [ 1023]: RECV: begin page
Jun 09 13:21:08.94: [ 1023]: RECV: send trigger 021
Jun 09 13:21:08.94: [ 1023]: Copy quality checking performed by host
Jun 09 13:21:31.82: [ 1023]: RECV: 0 total lines, 0 bad lines, 0 consecutive bad lines
Jun 09 13:21:31.82: [ 1023]: --> [10:+FPTS: 2,0]
Jun 09 13:21:31.82: [ 1023]: --> [7:+FET: 2]
Jun 09 13:21:31.82: [ 1023]: RECV recv EOP (no more pages or documents)
Jun 09 13:21:31.82: [ 1023]: --> [2:OK]
Jun 09 13:21:31.82: [ 1023]: RECV send RTN (retrain negative)
Jun 09 13:21:31.82: [ 1023]: <-- [10:AT+FPTS=2\r]
Jun 09 13:21:31.92: [ 1023]: --> [2:OK]
Jun 09 13:21:31.92: [ 1023]: <-- [7:AT+FDR\r]
Jun 09 13:21:43.59: [ 1023]: --> [10:+FHNG: 100]
Jun 09 13:21:43.59: [ 1023]: REMOTE HANGUP: Unspecified Phase D error (code 100)
Jun 09 13:21:43.59: [ 1023]: RECV keeping unconfirmed page
Jun 09 13:21:43.59: [ 1023]: RECV FAX (000008289): from IDENTIFICADOR, page 2 in 0:35, A4, 7.7 line/mm, 1-D MH, 14400 bit/s
Jun 09 13:21:43.59: [ 1023]: RECV FAX (000008289): recvq/fax000001777.tif from IDENTIFICADOR, route to <unspecified>, 2 pages in 0:58
Jun 09 13:21:43.59: [ 1023]: RECV FAX: Unspecified Phase D error
Jun 09 13:21:43.59: [ 1023]: RECV FAX (000008289): session with IDENTIFICADOR terminated abnormally: Unspecified Phase D error
Jun 09 13:21:43.59: [ 1023]: RECV FAX: /usr/local/bin/faxrcvd.bitmailer "recvq/fax000001777.tif" "ttyds01" "000008289" "Unspecified Phase D error" "914622115 DAD: 916596242" "914622115 DAD: 916596242"
Jun 09 13:21:43.59: [ 1023]: RECV FAX: end
Jun 09 13:21:43.59: [ 1023]: SESSION END
---------------------------------------------------


____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*