Re: [hylafax-users] Waiting for modem to come ready

[Bill Barasch <bill.barasch@creo.com>]

Sunil,

You can use faxgetty even if you are only going to be sending faxes and not receiving. That way you can get accurate faxstat information.

Bill

-----Original Message-----
From: Sunil William Savkar [mailto:savkar@inthespace.com]
Sent: Sunday, August 25, 2002 2:28 PM
To: 'Bill Barasch'; hylafax-users@hylafax.org
Subject: RE: [hylafax-users] Waiting for modem to come ready

Bill-

 

I am using faxmodem so perhaps this was all it is... interesting.

 

-----Original Message-----
From: Bill Barasch [mailto:bill.barasch@creo.com]
Sent: Sunday, August 25, 2002 4:10 AM
To: 'savkar@inthespace.com'; 'hylafax-users@hylafax.org'
Subject: RE: [hylafax-users] Waiting for modem to come ready

 

Are you using faxgetty or faxmodem.

Faxmodem will not give you the true state of the modem with faxstat program. http://www.hylafax.org/setup.php#Starting

 

Bill

-----Original Message-----
From: Sunil William Savkar [mailto:savkar@inthespace.com]
Sent: Sunday, August 25, 2002 1:36 AM
To: hylafax-users@hylafax.org
Subject: [hylafax-users] Waiting for modem to come ready

Hi.

 

Although hylafax appears to be working fine on my machine, whenever it is

waiting for some action, faxstat produces the following:

 

Modem ttySHCF0 (+1.718.852.6889): Waiting for modem to come ready

 

Is this all right?  I find it a bit strange.  In fact, there are a few times

during transmission that a fax may fail due to "no dial tone" but after a few

times finally go through.

 

I am currently using a Conexant HCF modem which amazingly appears to be

working even though it is a linmodem.

 

Best regards.

 

Sunil