Re: [hylafax-users] help to initialize multitech 56k modem

[Dmitry Bely <dbely@mail.ru>]

"Michel Donais" <donais@gsig-net.qc.ca> writes:

> > Operating System:     Sco Openserver 5.04
> > Modem :                   Multitech MT5600ZDXV
> >
> 
> > I understand it's a modem configuration problem but where to start
> > inding a solution any idea?
> > Sep 24 10:43:24 donsoft FaxGetty[702]: <-- [23:ATS8=2S7=60At&K3&D0&C1\r]
> 
> 
> > Change At&K3&D0&C1 to AT&K3&D0&C1 in your config. But this is a sign that
> > Hylafax is not fool-proof enough (it always expects config commands in the
> > upper case). Also all init commands possibly should be issued
> > separately...
> >
> Hi, Dmitry,
> 
> I finally succeded to put HylaFAX at work with an MT5600ZDXV modem.
> the initialisation strip should contain ATX4 to enable the modem to send
> back all information HylaFAX need to operate.

Very doubtful :-)

> The initstr should look as: ATX4&C1&D2E0V1M1L1S7=90S0=0

No way! Don't mix all setup commands (echo off, setup flow control, setup
volume etc.) into one init string -- there are special config parameters
available! Also init string lacks ATZ which is a must for reliable fax
operation. To make long story short, see my previous message -- the
solution is there.

> For the benefit of the list I can provide my configuration file for that
> kind of modem
> If somebody tells me where to send it.

It's not ready for the prime time yet :-)

Hope to hear from you soon,
Dmitry




____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null