Re: flexfax: How to control idle state?

[Nico Kadel-Garcia <raoul@cirl.meei.harvard.edu>]

-----BEGIN PGP SIGNED MESSAGE-----

On Thu, 30 Jul 1998, Jonathan Chen wrote:

> On Wed, 29 Jul 1998, Bob Worthy wrote:
> 
> > After grabbing a $25 modem that uses a Rockwell chip,
> > class 2 fax out works, but i have the same problem with mode switching
> > back to data.
> 
> [snip]
> 
> Heres an example snippet for a Rockwell-chip modem relevant config
> using faxgetty and class 2. The important bits are the
> ModemSetupAACmd, and the ModemResetCmd (which *shouldn't* contain ATZ)

I've copied the PPI 14400 FXMT setup, a Rockwell chip one, to my 
http://cirl.meei.harvard.edu/hylafax/ directory. My setup for this
agrees with Jonathan.

I have a 33.6 dialup modem, but haven't worked with it yet to do
fax/data (for reasons of lack of time).

			Nico Garcia
			Senior Engineer, CIRL 
			Mass. Eye and Ear Infirmary
			raoul@cirl.meei.harvard.edu

-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQCVAwUBNcCEnD/+ItycgIJRAQGo7QP+PqKhn6nsvyA8gywFsW2fK52OYePx6Dsh
vPE9JdvKw/xt/Qs0nKkegyq7WtcBFJRujaaXXRPcRNgMyshvhLoAk+WaYeLjeLm+
3eOQgrjxCi0LhQcJ9kwZwbuTdb3/uPnCaUBQqxshRzYfUo5clWwiCYXWp9L0eETo
MGa4kc7OgCM=
=8YH+
-----END PGP SIGNATURE-----