Re: flexfax: hylafax and diald

[Nico Kadel-Garcia <raoul@cirl.meei.harvard.edu>]

-----BEGIN PGP SIGNED MESSAGE-----

On Mon, 20 Jul 1998, J Kinsley wrote:

> I've gotten diald working by itself, and I've gotten hylafax
> working by itself.  However, when I have faxgetty controlling the
> modem, diald no longer works.  The reason being, after dialing
> the number (my ISP), the modem begins sending originating fax
> tones.  The remote picks up, hears the fax tones and terminates
> the call.  I have no idea what is causing this since the
> configuration files are backups of the ones that were working a
> week ago.  The only difference between now and then are the
> hylafax binaries I'm running.  Before I was running a set
> compiled locally (before installing pgcc), and since those were
> on one of the smoked hard drives, now I'm running the set from
> redhat contrib.  

There have been anumber of configuration changes in the bi8naries.
I suggest you examine the config.??? files, and look for changes.
In particular, consider putting "AT&F" at the beginning of
your dial-out initialization string to put it in factory default
mode rather than whatever state HylaFAX left it in last.

> In addition, if I run minicom while faxgetty is running, it does
> not initilize properly upon startup.  I must issue a manual
> initilize command (^a-m).  I've turned up the logging level on
> hylafax, but nothing appears out of the ordinary.

See above.


			Nico Garcia
			Senior Engineer, CIRL 
			Mass. Eye and Ear Infirmary
			raoul@cirl.meei.harvard.edu

-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQCVAwUBNbPFqj/+ItycgIJRAQGZhwP/QUPjFqViXgooFcnYmgG2OZSSTSTMlTaB
1EuFWhe5lygTD53P3NUT9/lZbzl4ognqLdR7DBF0UPrLT/cgKWxDJhgV86ccIZW7
VVhDzVuU+nwERI6mVDiyYoNJIPvj0YSa1yCk6tO1OWIoingbIvDeBQZ0Mw2+xZk3
rfDuPibA7mw=
=XsHE
-----END PGP SIGNATURE-----