Re: [hylafax-users] Error Correction

[James Smith <James.Smith@xxxxxxxxx>]

Suppose my next couple of questions would be this:-

 

Does anybody know if the usr sportster 56k model 0701 supports error correction?

 

The other question would be about the modem config.tty file

 

In the config file none of the parameters have double quotes round them, but the example in the hylafax documentation does - do the quotes make any difference?

 

Is

Class2DCCQueryCmd:     "!(0,1),(0-5),(0-4),(0-2),(0),(0-3),(0),(0-7)"

 

The same as

Class2DCCQueryCmd:     !(0,1),(0-5),(0-4),(0-2),(0),(0-3),(0),(0-7)

 

?

 

Thx

 

James S

 

-----Original Message-----

From: Siri Vias Khalsa [mailto:sirivias.khalsa@xxxxxxxxxx]

Sent: Wednesday, February 04, 2009 1:48 PM

To: James Smith

Cc: hylafax-users@xxxxxxxxxxx

Subject: Re: [hylafax-users] error correction

 

It means tat it wasnt enabled for the call. Likely one side or the other wasnt configured to allow it or couldnt support it for some reason. It is typical to disable this when either side is using VoIP lines.

 

-Siri Vias

 

On Wed, 2009-02-04 at 09:43 -0600, James Smith wrote:

> This might be a daft question, but here goes

>

> 

>

> In the email I get when an incoming fax is precessed it says :-

>

> 

>

> Error Correct: No

>

> 

>

> Does this mean that error correction wasn’t available or that it just

> wasn’t used?

>

> 

>

> Thx

>

> 

>

> James S

>

> 

>

>

--

 

 

-Siri Vias

 

Siri Vias Khalsa

Verifi, Inc.

Senior Systems Administrator

sirivias.khalsa@xxxxxxxxxx

323-655-5789 x125 office

310-498-3975 cell