[hylafax-users] Problem to sending or receiving faxes

["Carlos Carranza" <carlosecarranza@xxxxxxxxxxx>]

Hi, I´m using HylaFAX 4.3.3 and IAXModem 0.1.14-1 into Elastix 1.1-7 distribution,

I can´t send or receive faxes at all. Including send from an extension to

another one in the same server.

 

All faxes received from another fax machine in that context:

Fax Machine -- > PSTN -- > FXO GW with FAX Support -- > Asterisk -- > HylaFAX alaw code is used for whole route.

Allways I received the following response:

"No answer (T.30 T1 timeout)"

 

What´s could be happening?

Thank in advance.

 

PD: The error when a send from an extension to another one, is as following:

 

Your job to 4002 failed because:

 

 

 

 

    ---- Transcript of session follows ----

 

Oct 06 14:04:51.04: [15022]: SESSION BEGIN 000000068 543514002 Oct 06 14:04:51.04: [15022]: HylaFAX (tm) Version 4.3.3 Oct 06 14:04:51.04: [15022]: SEND FAX: JOB 17 DEST 4002 COMMID 000000068 DEVICE '/dev/ttyIAX1' FROM '4002 <ccarranza@xxxxxxxxxxxxx>' USER 4002 Oct 06 14:04:51.04: [15022]: STATE CHANGE: RUNNING -> SENDING Oct 06 14:04:51.04: [15022]: <-- [12:AT+FCLASS=1\r] Oct 06 14:04:51.04: [15022]: --> [2:OK] Oct 06 14:04:51.04: [15022]: MODEM set XON/XOFF/FLUSH: input ignored, output disabled Oct 06 14:04:51.08: [15022]: DIAL 4002 Oct 06 14:04:51.08: [15022]: <-- [9:ATDT4002\r] Oct 06 14:04:54.42: [15022]: --> [7:CONNECT] Oct 06 14:04:56.28: [15022]: --> HDLC<34:FF C0 04 B5 00 AA 12 9E 36 86 62 82 1A 04 14 2E B6 94 04 6A A6 4E CE 96 F6 76 04 2C 74 CC 74 CC DA 7F> Oct 06 14:04:56.28: [15022]: --> [2:OK] Oct 06 14:04:56.28: [15022]: REMOTE NSF "AD 00 55 48 79 6C 61 46 41 58 20 28 74 6D 29 20 56 65 72 73 69 6F 6E 20 34 2E 33 2E 33"

Oct 06 14:04:56.28: [15022]: NSF remote fax equipment: HylaFAX Oct 06 14:04:56.28: [15022]: NSF remote station ID: "HylaFAX (tm) Version 4.3.3"

Oct 06 14:04:56.28: [15022]: <-- [9:AT+FRH=3\r] Oct 06 14:04:56.28: [15022]: --> [7:CONNECT] Oct 06 14:04:57.12: [15022]: --> HDLC<25:FF C0 02 82 D4 12 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 E2 59> Oct 06 14:04:57.12: [15022]: --> [2:OK] Oct 06 14:04:57.12: [15022]: REMOTE CSI "H+A"

Oct 06 14:04:57.12: [15022]: <-- [9:AT+FRH=3\r] Oct 06 14:04:57.12: [15022]: --> [7:CONNECT] Oct 06 14:04:57.66: [15022]: --> HDLC<15:FF C8 01 00 73 5F 23 01 FB C1 01 01 18 90 61> Oct 06 14:04:57.74: [15022]: --> [2:OK] Oct 06 14:04:57.75: [15022]: REMOTE best rate 9600 bit/s Oct 06 14:04:57.75: [15022]: REMOTE max A3 page width (303 mm) Oct 06 14:04:57.75: [15022]: REMOTE max unlimited page length Oct 06 14:04:57.75: [15022]: REMOTE best vres R16 x 15.4 line/mm Oct 06 14:04:57.75: [15022]: REMOTE format support: MH, MR, MMR Oct 06 14:04:57.75: [15022]: REMOTE supports T.30 Annex A, 256-byte ECM Oct 06 14:04:57.75: [15022]: REMOTE best 0 ms/scanline Oct 06 14:04:57.75: [15022]: USE 9600 bit/s Oct 06 14:04:57.75: [15022]: USE error correction mode Oct 06 14:04:57.75: [15022]: <-- [9:AT+FTH=3\r] Oct 06 14:04:57.75: [15022]: --> [7:CONNECT] Oct 06 14:04:57.75: [15022]: <-- HDLC<3:FF C8 DF> Oct 06 14:04:58.93: [15022]: --> [2:OK] Oct 06 14:04:58.93: [15022]: MODEM input buffering enabled Oct 06 14:04:58.93: [15022]: <-- [5:ATH0\r] Oct 06 14:04:59.04: [15022]: --> [2:OK] Oct 06 14:04:59.04: [15022]: MODEM set DTR OFF Oct 06 14:04:59.04: [15022]: MODEM set baud rate: 0 baud (flow control unchanged) Oct 06 14:04:59.04: [15022]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5) Oct 06 14:04:59.04: [15022]: SESSION END

 

------- Unsent job status -------

      Destination: 4002

            JobID: 17

          GroupID: 17

           Sender: 4002

         Mailaddr: ccarranza@xxxxxxxxxxxxx

           CommID: 000000068

            Modem: any

   Submitted From: 10.201.1.126

       Page Width: 209  (mm)

      Page Length: 296 (mm)

       Resolution: 196 (lpi)

           Status:

          Dialogs: 1

            Dials: 0

            Calls: 1

            Pages: 0

         TotPages: 0

         Attempts: 0

           Dirnum:

 

In the /etc/hylafax/etc/xferfaxlog said:

 

"RSPREC error/got DCN"

 

10/06/08 14:04  CALL    000000069       ttyIAX2         ""      fax     "+54"   ""      0       0       0:07    0:07    "RSPREC error/got DCN"  "FAX 1" "4001"  "<NONE>::s"     ""      ""