[hylafax-users] T38modem and Hylafax issues

["Jennifer Eyrich" <jce@xxxxxxxxxxx>]

Hello,

 

I installed Hylafax and T38modem.

 

I configured T38modem as described in the README file except I used the IP address of my media gateway for the route all.  I tested the two modems ttyx0 and ttyx1 using cu and everything seems fine.

 

I configured Hylafax to use the modem by using faxgetty -D ttyx0 etc as indicated in the T38modem README file.  Tested the class info etc as indicated in the Hylafax documentation.  Created a test user.

 

Everything seems fine and that is where the problems start.

 

1.  When I first configured the T38modem, I did it thru the terminal window and left it open.  While that window was open, it showed the receive data etc between the two modems while I was testing.

The moment I close the window that I used to configure the T38modem, I get input/output errors using the cu command for the pseudo modems. 

Does this window have to be kept open?  When I reopen the window to run T38modem, I have to recreate the modems again...

 

2.  I used a hylafax client to test sending faxes and they sit in the queue.  The log shows that the modems are wedged...

 

So I am stuck at this point, could someone assist?

 

 

faxgetty is running and so it faxq.  The client shows that the Hylafax scheduler is running.

 

I would be happy to supply more info upon request.

 

Thanks,

 

 

 

Jennifer C. Eyrich |Network Administrator
Resnick Amsterdam Leshner, PC | 653 Skippack Pike, Suite 300 |Blue Bell, Pa 19422
Phone - 215.628.8080  x139 | Fax - 215.628.4752 |Website - www.ral-cpa.com