HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

[hylafax-users] Time out problem.



HI,
 
I am new to hylafax. i am getting message as follows:
 
REMOTE HANGUP: T.30 T1 timeout after EOM received (code 74)
 
 
Following is my modem settings:
CountryCode:            1
AreaCode:               952
FAXNumber:              +1.952.828.9867
LongDistancePrefix:     1
InternationalPrefix:    011
DialStringRules:        etc/dialrules
ServerTracing:          1
SessionTracing:         11
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "fax test"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
QualifyCID:             /var/spool/hylafax
QualifyTSI:             /var/spool/hylafax
MaxRecvPages:           100
LockDataCalls:          yes
LockVoiceCalls:         yes
 
 
ModemType:              Class2          # use class 2 interface
ModemRate:              19200           # lock rate for DCE-DTE communication
ModemFlowControl:       rtscts          # default
#
ModemHardFlowCmd:       AT&E4           # hardware flow control
ModemSoftFlowCmd:       AT&E5           # software flow control
ModemSetupDTRCmd:       AT&D3           # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier (or not)
# The MT2834ZDX (and other newer models) may be more robust with this.
#ModemSetupDCDCmd:      AT&C4           # setup so DCD resets modem on
#                                       # carrier drop
#
ModemSetupAACmd:        AT+FAA=1        # enable adaptive-answer in class 2
#
# NB: some models get confused by @ in ModemDialCmd
# NB: the @ causes some multifunction fax units to not go into fax mode.
#
ModemDialCmd:           ATDT%s          # T for tone dialing
#
Class2RecvDataTrigger:  "\022"          # character sent to modem to start recv
 
I use a Multitech modem. Pls advice me.
 
Regards
Dinesh D
 



Project hosted by iFAX Solutions