[hylafax-users] no response to PPS repeated 3 times

[marthter <marthter@xxxxxxxx>]

Hello list,

I have the following system:
Hylafax 4.2.5 compiled/installed from .tar.gz
Fedora Core 4
Multitech 5634ZPX-PCI modem  in class 1.0

Archives searching turned up users with this problem with USR modems, or 
with international calls, but neither applies to me.

A July 20, 2005 post of Lee's suggests "V.29  9600 baud (sendfax -B 
9600)".  Is that equally applicable here?

I guess that would be maxSignallingRate:"9600" in 
/var/spool/hylafax/info/[canonical of dest number]  ?

Thanks for any tips.

Martin




Your facsimile job to -snip- failed because:
   No response to PPS repeated 3 times.; too many attempts to dial

   ---- Transcript of session follows ----

May 20 11:05:51.25: [31356]: SESSION BEGIN 000012197 -snip-
May 20 11:05:51.25: [31356]: HylaFAX (tm) Version 4.2.5
May 20 11:05:51.25: [31356]: SEND FAX: JOB 13510 DEST -snip- COMMID 000012197 DEVICE '/dev/ttyS14' FROM '-snip- <-snip->' USER -snip-
May 20 11:05:51.25: [31356]: STATE CHANGE: RUNNING -> SENDING
May 20 11:05:51.25: [31356]: <-- [14:AT+FCLASS=1.0\r]
May 20 11:05:51.25: [31356]: --> [2:OK]
May 20 11:05:51.25: [31356]: <-- [14:AT+F34=14,1,2\r]
May 20 11:05:51.26: [31356]: --> [2:OK]
May 20 11:05:51.26: [31356]: DIAL -snip-
May 20 11:05:51.26: [31356]: <-- [15:ATDT-snip-\r]
May 20 11:06:05.80: [31356]: --> [9:+F34:11,1]
May 20 11:06:05.80: [31356]: V.8 handshaking succeeded, V.34-Fax (SuperG3) capability enabled.
May 20 11:06:05.80: [31356]: Primary channel rate: 26400 bit/s, Control channel rate: 1200 bit/s.
May 20 11:06:05.80: [31356]: --> [7:CONNECT]
May 20 11:06:05.80: [31356]: Control channel selected
May 20 11:06:06.27: [31356]: --> HDLC<53:FF C0 04 00 00 98 34 03 05 7B D9 BF 1F F7 03 0D 05 91 80 30 C2 3A 82 04 04 9A A2 32 22 82 4A 42 20 80 E0 E0 80 B0 10 D0 0E A0 40 98 00 60 80 20 E0 80 80 ED ED>
May 20 11:06:06.27: [31356]: REMOTE NSF "00 00 19 2C C0 A0 DE 9B FD F8 EF C0 B0 A0 89 01 0C 43 5C 41 20 20 59 45 4C 44 41 52 42 04 01 07 07 01 0D 08 0B 70 05 02 19 00 06 01 04 07 01 01"
May 20 11:06:06.27: [31356]: NSF remote fax equipment: Xerox 
May 20 11:06:06.27: [31356]: NSF remote station ID: "BRADLEY  A\C"
May 20 11:06:06.46: [31356]: --> HDLC<25:FF C0 02 8C 0C CC 9C 6C 6C AC 0C 9C 04 04 04 04 04 04 04 04 04 04 04 80 41>
May 20 11:06:06.46: [31356]: REMOTE CSI "905669301"
May 20 11:06:06.56: [31356]: --> HDLC<11:FF C8 01 04 77 1F 23 01 F8 F7 50>
May 20 11:06:06.56: [31356]: REMOTE best rate 33600 bit/s
May 20 11:06:06.56: [31356]: REMOTE max A4 page width (215 mm)
May 20 11:06:06.56: [31356]: REMOTE max unlimited page length
May 20 11:06:06.56: [31356]: REMOTE best vres R16 x 15.4 line/mm
May 20 11:06:06.56: [31356]: REMOTE format support: MH, MR, MMR
May 20 11:06:06.56: [31356]: REMOTE supports T.30 Annex A, 256-byte ECM
May 20 11:06:06.56: [31356]: REMOTE best 0 ms/scanline
May 20 11:06:06.56: [31356]: USE 26400 bit/s
May 20 11:06:06.56: [31356]: USE error correction mode
May 20 11:06:06.56: [31356]: SEND file "docq/doc13510.ps;f1"
May 20 11:06:06.56: [31356]: USE A4 page width (215 mm)
May 20 11:06:06.56: [31356]: USE unlimited page length
May 20 11:06:06.56: [31356]: USE 7.7 line/mm
May 20 11:06:06.56: [31356]: USE 2-D MMR
May 20 11:06:06.56: [31356]: USE 0 ms/scanline
May 20 11:06:06.56: [31356]: <-- HDLC<23:FF C0 C2 26 36 A6 96 66 D6 F6 F6 4E 42 04 04 04 04 04 04 04 04 04 04>
May 20 11:06:06.56: [31356]: <-- HDLC<7:FF C8 C1 00 42 1F 22>
May 20 11:06:07.01: [31356]: --> HDLC<5:FF C8 21 57 BE>
May 20 11:06:07.01: [31356]: SEND begin page
May 20 11:06:07.01: [31356]: SEND EOFB
May 20 11:06:07.01: [31356]: SEND send frame number 0
May 20 11:06:07.01: [31356]: SEND send frame number 1
May 20 11:06:07.01: [31356]: SEND send frame number 2
May 20 11:06:07.01: [31356]: SEND send frame number 3

-snip-

May 20 11:06:07.02: [31356]: SEND send frame number 131
May 20 11:06:07.02: [31356]: SEND send frame number 132
May 20 11:06:07.02: [31356]: SEND send frame number 133
May 20 11:06:09.19: [31356]: Primary channel selected
May 20 11:06:20.56: [31356]: Control channel selected
May 20 11:06:20.57: [31356]: <-- HDLC<7:FF C8 FD F4 00 00 A1>
May 20 11:06:20.57: [31356]: SEND send PPS (partial page signal)
May 20 11:06:20.57: [31356]: SEND send EOP (no more pages or documents)
May 20 11:06:21.11: [31356]: --> HDLC<37:FF C8 3D 00 02 00 00 00 00 00 00 00 00 00 00 02 00 00 02 03 FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF 89 BE>
May 20 11:06:21.11: [31356]: SEND recv PPR (partial page request)
May 20 11:06:21.11: [31356]: SEND send frame number 14
May 20 11:06:21.11: [31356]: SEND send frame number 102
May 20 11:06:21.11: [31356]: SEND send frame number 126
May 20 11:06:23.03: [31356]: Primary channel selected
May 20 11:06:23.78: [31356]: Control channel selected
May 20 11:06:23.78: [31356]: <-- HDLC<7:FF C8 FD F4 00 00 40>
May 20 11:06:23.78: [31356]: SEND send PPS (partial page signal)
May 20 11:06:23.78: [31356]: SEND send EOP (no more pages or documents)
May 20 11:06:24.07: [31356]: --> HDLC<5:FF C8 31 45 8F>
May 20 11:06:24.07: [31356]: SEND recv MCF (message confirmation)
May 20 11:06:26.25: [31356]: Primary channel selected
May 20 11:06:26.74: [31356]: Control channel selected
May 20 11:06:26.74: [31356]: <-- HDLC<7:FF C8 FD F4 00 00 00>
May 20 11:06:26.74: [31356]: SEND send PPS (partial page signal)
May 20 11:06:26.74: [31356]: SEND send EOP (no more pages or documents)
May 20 11:06:31.74: [31356]: MODEM TIMEOUT: receiving HDLC frame data
May 20 11:06:31.74: [31356]: <-- HDLC<7:FF C8 FD F4 00 00 00>
May 20 11:06:31.74: [31356]: SEND send PPS (partial page signal)
May 20 11:06:31.74: [31356]: SEND send EOP (no more pages or documents)
May 20 11:06:32.34: [31356]: EOT received (end of transmission)
May 20 11:06:32.34: [31356]: No response to PPS repeated 3 times.
May 20 11:06:32.34: [31356]: SEND end page
May 20 11:06:32.34: [31356]: <-- HDLC<3:FF C8 DF>
May 20 11:06:32.34: [31356]: MODEM input buffering enabled
May 20 11:06:32.34: [31356]: SEND FAILED: JOB 13510 DEST -snip- ERR No response to PPS repeated 3 times.; too many attempts to dial
May 20 11:06:32.34: [31356]: --> [2:OK]
May 20 11:06:32.34: [31356]: <-- [5:ATH0\r]
May 20 11:06:32.69: [31356]: --> [2:OK]
May 20 11:06:32.69: [31356]: MODEM set DTR OFF
May 20 11:06:32.69: [31356]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5)
May 20 11:06:32.69: [31356]: SESSION END

   ---- Unsent job status ----

    Destination: -snip- 
          JobID: 13510
        GroupID: 13510
         Sender: -snip- 
       Mailaddr: -snip-
         CommID: 000012197
 Submitted From: -snip-
     Page Width: 216 (mm)
    Page Length: 279 (mm)
     Resolution: 196 (lpi)
         Status: No response to PPS repeated 3 times.; too many attempts to dial
        Dialogs: 1 (exchanges with remote device)
          Dials: 0 (consecutive failed calls to destination)
          Calls: 1 (total phone calls placed)
          Pages: 0 (pages transmitted)
       TotPages: 1 (total pages to transmit)
       Attempts: 1 (attempts to send current page)
         Dirnum: 0 (directory of next page to send)

   ---- Documents submitted for transmission ----

The following documents were submitted for transmission and are
available on the server for reuse until they are automatically
purged when this job is removed.  Documents may also be manually
removed using the faxrm command; consult faxrm(1) for information.

Filename                 Size Type
docq/doc13510.ps       148748 PostScript



____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*