Re: [hylafax-users] Mainpine Rockforce Octo+, Hylafax and DTMF

["Support" <support@xxxxxxxxxxxx>]

Title: Mainpine Rockforce Octo+, Hylafax and DTMF

Hi Pawel.

 

I don't know the answer to your HylaFAX specific questions.  However, I would suggest that you begin by using minicom to test that your PBX is delivering the DTMF digits to the card as follows;

 

Set modem to voice mode with AT+FCLASS=8

Answer incoming call with AT+VLS=1

Check you get the extra 4 DTMF digits which minicom should display as shielded codes.

 

If this does not work then I would suggest that you disable the PBX DTMF forwarding and do the following;

 

Set modem to voice mode with AT+FCLASS=8

Answer incoming call with AT+VLS=1

Type extra digits on the calling handset which minicom should display as shielded codes.

 

Once you're convinced that the PBX is delivering the extra 4 digits then turn on the HylaFAX logging and post the resulting file here for comment.

 

You should also upgrade to 4.2.2 because of the extensive work that has been undertaken in the Class 1/1.0 driver.

 

Regards

 

ANDREW RINALDI

Mainpine Support Manager

USA +1 718 701 2422 | Asia/Europe +44 1225 436137 

andrew.rinaldi@xxxxxxxxxxxx | www.mainpine.com

---

From: hylafax-users-bounce@xxxxxxxxxxx [mailto:hylafax-users-bounce@xxxxxxxxxxx] On Behalf Of Pawel K. Kowalke
Sent: 26 September 2005 18:07
To: hylafax-users@xxxxxxxxxxx
Subject: [hylafax-users] Mainpine Rockforce Octo+, Hylafax and DTMF

>I have posted this on fa.hylafax but got no answer. Does anyone on this list have a hint ?
Hello,
I am trying to get the Rockforce (Octo+) card to work with DTMF digit
detection in Hylafax 4.2.0. I got my PBX to send 4 digits to the phone
line.
I tried few solutions out there, each of them involved modifying
etc/config.ttySx file. For example:
ModemRingResponse: AT+FCLASS=8;H1
CIDNumber: SHIELDED_DTMF
CIDNumberAnswerLength: 4
ModemAnswerCmd: AT+FCLASS=1;A
Unfortunately, that alone does not seem to work. Does anyone out there
have some suggestions or maybe even solutions :)? I would really
appreciate any help.
Greetings,
Pawel Kowalke