[hylafax-users] Designating group of modems to specific task

[Eric Butler <ericb@xxxxxxxxxxx>]

Hi,

We've got Hylafax set up and properly sending/recieving faxes, however there are a few things I would like to change that I have not been able to get working.

The system has 48 modems (ttyG000-ttyG047), I would like modems 0-24 to only handle incoming faxes, and 25-45 (leaving two remaining) to handle only outgoing.  I also would like to make sure hylafax will send multiple faxes to the same destination at once rather than create a queue and send them one at a time.

Faxgetty is only running for 0-24 so from what I can tell incoming faxes are already going to be handled properly. As for outgoing I suspect it is a simple misconfiguration on my part.

In /var/spool/hylafax/etc/config.<devname> I have:

ModemGroup: "outgoing: ttyG0[25,26,27,28,29,30,31,32,33,34,35,36,37,38,39,40,41,42,43,44,45]"

In /var/spool/hylafax/etc/destctrls I have:

.*      Modem = outgoing
.*      MaxConcurrentJobs = unlimited

I appologize if this question has already been asked on the list before, but I was unable to find an answer while searching the archives.

Thanks,

Eric Butler
Engineering Dept.
LION, Inc. 

____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxxxxx*