Re: [hylafax-users] new user - faxaddmodem problems

[Tom Smith <tom@openadventures.org>]

The preferred way to setup the modem for HylaFax use is via 
/etc/inittab. This just seems to work better and has fewer problems.

Go to http://www.hylafax.org/setup.php#Inbound - this will setup 
HylaFax to use the modem and its ability to receive faxes.

If you don't want to receive faxes, then change RingsBeforeAnswer to 0 
in etc/config.<devid>. This will enable a send-only environment for HylaFax.

Tom Smith
tom@openadventures.org
http://www.openadventures.org

Jim Whitesell wrote:

> Hi All,
>
> I'm in the process of setting up hylafax on a RH 7.2 box, using a 
> MultiTech MT2834ZDX external modem (chosen because it is listed to 
> work well with hylafax) on COM 1. I installed using the RH RPM 
> (hylafax-4.1.5-1rh7.i386.rpm)
>
> The modem is seen by wvdialconf, and works properly in Minicom. There 
> are no other serial devices on this machine.
>
> However, when I run faxaddmodem and it asks what serial port the modem 
> is connected to, it responds with:
>
> /dev/1 is not a terminal device
>
> Same reply for /dev/0 (I wasn't sure if I should enter the serial port 
> - 1 - or the ttyS0 number zero, so I tried both)
>
> I've poked around hlyafax.org most of the afternoon, but haven't found 
> a solution to this problem. Any suggestions?
>
> Thanks
>
>
> ____________________ HylaFAX(tm) Users Mailing List 
> _______________________
>  To subscribe/unsubscribe, click 
> http://lists.hylafax.org/cgi-bin/lsg2.cgi
> On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < 
> /dev/null
>  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*




____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*