HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [hylafax-users] multitech MT5600ZDXE/hylafax 4.0pl2



On Sunday, August 13, 2000, at 8:48:43 PM, Damian Ivereigh wrote:
> "Jay R. Ashworth" wrote:
>> We're using the 56000zdx's quite happily, with the shipped Multitech
>> config file.  The trick is to remove the @ at the end of the
>> dialstring.  The firmware in that modem doesn't seem to recognize that
>> trick.

Ah; hi, Damian.  Hadn't seen you around lately.

> I don't know about the MT5600ZDXE, but when we changed from the
> MT2834Z to the MT5634Z I had to change the lines:-

> ModemHardFlowCmd:       AT&E4           # hardware flow control
> ModemSoftFlowCmd:       AT&E5           # software flow control

> to

> ModemHardFlowCmd:       AT&K3           # hardware flow control
> ModemSoftFlowCmd:       AT&K4           # software flow control

> Otherwise sometimes the modem would refuse to dial (and we don't have
> a '@' at the end of the dialstring).

I'll keep that in mind, in case I note problems.  12 page jobs seem to
be going bang-up, though.

Cheers,
-- jra
-- 
Jay R. Ashworth                                                jra@baylink.com
Member of the Technical Staff     
The Suncoast Freenet
Tampa Bay, Florida     http://baylink.pitas.com                +1 727 804 5015




____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null




Project hosted by iFAX Solutions