HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Problem with sending



Greetings,

I installed hylafax 4.1 Beta 2 a while ago...after a struggle, I finally 
got it working...however, over the last month, I have not been able to send 
out a fax...I get a message stating that there was problem with conversion 
of the documents..below I have attached an example of the output..I have 
only sent out about 5 faxes before it stopped..I have sent only text 
messages......any suggestions...?

the HyLaFax is on a Red hat Linux 6.1 /Linux 2.2.-20 #2

Included is a part of the msg::::
++++++++++++++++++++++++++++++++++++++++++++++++++++++
Your facsimile job to 7036914020 was not sent because document conversion
to facsimile failed. The output from the converter program was:


Check any PostScript documents for non-standard fonts and invalid constructs.
---- Unsent job status ----
Destination: 7036914020
JobID: 24
GroupID: 24
Sender: del
Mailaddr: del@cais.com
Submitted From: localhost.localdomain
Page Width: 215 (mm)
Page Length: 279 (mm)
Resolution: 196 (lpi)
Status: (nothing available)
Dialogs: 0 (exchanges with remote device)
Dials: 0 (consecutive failed calls to destination)
Calls: 0 (total phone calls placed)
Pages: 0 (pages transmitted)
TotPages: 0 (total pages to transmit)
Attempts: 0 (attempts to send current page)
Dirnum: 0 (directory of next page to send)

++++++++++++++++++++++++++++++++++++++++++++++++++++++

donnie




Project hosted by iFAX Solutions