Re: flexfax: DTMF routing using Hylafax.

["Jay R. Ashworth" <jra@baylink.com>]

On Wed, May 12, 1999 at 04:03:48PM +0800, NetWork 2020 wrote:
> > > Any one can tell me how to use DTMF routing in Hylafax.
> > 
> > You will need to change the source code, after finding a modem that
> > will answer but not try and negotiate fax mode, but can be then forced
> > to negotiate fax mode without dropping the line.  This probably means
> > using a voice mode and initially accepting the call in voice mode.
> > 
> > The only support for automatic routing is based on source information
> > transmitted as CLI and/or (can't remember which) calling line ID or
> > fax transmitting station ID.
> 
> Thanks, but it is not easy to done.

Yes; that's roughly what David was telling you.

:-)

Cheers,
-- jra
-- 
Jay R. Ashworth                                                jra@baylink.com
Member of the Technical Staff     Buy copies of The New Hackers Dictionary.
The Suncoast Freenet            Give them to all your friends.
Tampa Bay, Florida     http://www.ccil.org/jargon/             +1 813 790 7592