HylaFAX The world's
most advanced open source fax server
|
|
[
Date Prev][
Date Next][
Thread Prev][
Thread Next]
[
Date Index]
[
Thread Index]
Paging won't retry after "...Unable to configure..."
- To: <flexfax@sgi.com>
- Subject: flexfax: Paging won't retry after "...Unable to configure..."
- From: "Paul Dugas" <pdugas@inetnow.net>
- Date: Tue, 9 Jun 1998 08:45:26 -0400
Hi all,
I've got a HylaFAX server (v4.0-pl1) on a Sun SPARC (Solaris 2.5.1). We're
currently using it strictly for alpha-numeric paging. I've been tweaking
it off and on now for a few months and have it working very well with one
exception. Occasionally (about one in 250 messages), the server is unable
to configure the modem and sends me the following
Your pager job to 9,4046564342 failed because:
Unable to configure modem for data use
---- Transcript of session follows ----
Jun 08 20:15:30.64: [19092]: SESSION BEGIN 00015189 14046564342
Jun 08 20:15:30.64: [19092]: SEND PAGE: JOB 15551 DEST 9,4046564342 COMMID
00015189
Jun 08 20:15:30.64: [19092]: DELAY 2600 ms
Jun 08 20:15:35.46: [19092]: <-- [15:ATE0V1Q0S0=0H0\r]
Jun 08 20:15:40.47: [19092]: MODEM <Timeout>
Jun 08 20:15:40.47: [19092]: <-- [5:ATM0\r]
Jun 08 20:16:10.48: [19092]: MODEM <Timeout>
Jun 08 20:16:10.49: [19092]: <-- [12:AT+FCLASS=0\r]
Jun 08 20:16:40.50: [19092]: MODEM <Timeout>
Jun 08 20:16:40.50: [19092]: PAGE FAILED: Unable to configure modem for
data use
Jun 08 20:16:40.53: [19092]: SESSION END
---- Unsent job status ----
Destination : 9,4046564342
JobID : 15551
GroupID : 15551
Sender : Nobody
Mailaddr : nobody@netra.atms.dot.state.ga.us
CommID : 00015189
Submitted From : localhost
Status : Unable to configure modem for data use
Dialogs : 0 (exchanges with remote device)
Dials : 0 (consecutive failed calls to destination)
Calls : 0 (total phone calls placed)
When this happens, the message in question is dumped and never retried. The
next time the modem is used, it works fine. I'm reluctant to fiddle with
the modem strings as they seem to work so much if the time. I'd really like
to make it retry the message. Why does it not retry?
Any help or suggestions would be greatly appreciated. Thanks in advance,
-Paul
--
Paul Dugas, GTC Systems
1711 Indian Ridge Dr, Woodstock, GA, USA
email:pdugas@inetnow.net voice:404-635-8026 fax:404-635-8001