Re: flexfax: sendpage to german D1 fails

[Matthias.Apitz@SOFTCON.de]

Holger Pfaff wrote:
    
    Hi!
    
    I tried to send SMS messages to the german D1 network but the modem
    always reports a busy line after several seconds:
    
    Feb 02 14:01:42.68: [ 6302]: SESSION BEGIN 00000575 1712092522
    Feb 02 14:01:42.68: [ 6302]: SEND PAGE: JOB 335 DEST 001712092522 COMMID
    00000575
    Feb 02 14:01:42.69: [ 6302]: MODEM set DTR OFF
    Feb 02 14:01:42.69: [ 6302]: DELAY 2600 ms
    Feb 02 14:01:45.29: [ 6302]: MODEM set DTR ON
    Feb 02 14:01:45.29: [ 6302]: MODEM set baud rate: 38400 baud, input flow
    RTS/CTS, output flow RTS/CTS
    Feb 02 14:01:45.29: [ 6302]: MODEM flush i/o
    Feb 02 14:01:45.30: [ 6302]: <-- [15:ATE0V1Q0S0=0H0\r]
    Feb 02 14:01:45.45: [ 6302]: --> [2:OK]
    Feb 02 14:01:45.45: [ 6302]: <-- [21:ATS8=2S7=60&K3&D2&C1\r]
    Feb 02 14:01:45.60: [ 6302]: --> [2:OK]
    Feb 02 14:01:45.60: [ 6302]: <-- [5:ATM0\r]
    Feb 02 14:01:45.75: [ 6302]: --> [2:OK]
    Feb 02 14:01:45.75: [ 6302]: MODEM set parity: 7 bits, even parity
    Feb 02 14:01:45.75: [ 6302]: MODEM input buffering enabled
    Feb 02 14:01:45.77: [ 6302]: <-- [12:AT+FCLASS=0\r]
    Feb 02 14:01:46.02: [ 6302]: --> [2:OK]
    Feb 02 14:01:46.02: [ 6302]: DIAL 001712092522
    Feb 02 14:01:46.02: [ 6302]: <-- [20:ATX3DT001712092522@\r]

remove the "@" from your ModemDialCmd: to see if it is really
BUSY or something else (perhaps); the D1 SMSC wants V.22
check your modem manual how to set this into PagerSetupCmds:
config parameter;

	matthias

    Feb 02 14:02:09.70: [ 6302]: --> [4:BUSY]
    Feb 02 14:02:09.70: [ 6302]: PAGE FAILED: Busy signal detected
    Feb 02 14:02:09.70: [ 6302]: <-- [5:ATH0\r]
    Feb 02 14:02:09.95: [ 6302]: --> [2:OK]
    Feb 02 14:02:09.95: [ 6302]: MODEM input buffering enabled
    Feb 02 14:02:09.95: [ 6302]: MODEM set DTR OFF
    Feb 02 14:02:09.95: [ 6302]: SESSION END
    
    Hylafax 4.0
    Solaris 2.5
    Creatix  LC144VF
    
    Any Ideas?
    
    -- Holger