![]() |
> Did you run the netstat(1) while a telnet session to port > 4559 was in progress? If there is no client connection to > port 4559 it will show only the LISTEN, if there is a > connection to port 4559 it will also schow ESTABLISHED lines. Yes, I did: tcp 0 0 127.0.0.1.4559 127.0.0.1.1025 ESTABLISHED tcp 0 0 127.0.0.1.1025 127.0.0.1.4559 ESTABLISHED tcp *.* 4559 LISTEN > The "-I" will only work if hfaxd(1M) is started from the inetd(1M) > via an entry in inetd.conf(4F). "-I" means: the client/server > protocol is using stdin and stdout (these file descriptors are > handed over by inetd(1M) as a connected socket). If you use > "-I" in a boot-time start script it will not work. On the > other hand you can't use "-i hylafax" in inetd.conf(4F) because > inetd(1M) is listening on port "hylafax" and not hfaxd(1M) itself. > Your error message below "4559 in use" will be the result of > using "-i hylafax" in inetd.conf(4F). In inetd.conf(4F) you must > use "-I". inetd.conf: hylafax stream tcp nowait fax /usr/contrib/lib/hylafax/hfaxd hfaxd -I rc: /usr/contrib/bin/faxq /usr/contrib/lib/hylafax/hfaxd -i .... After reboot, only faxq shows up as a process and the error message during bootup says: hylafax usage [-i port] [-o port] [-s port] I then go to /usr/contrib/lib/hylafax directory and type: ./hfaxd -i 4559 HylaFax starts up and I get the following error in the daemonlog: HylaFax INET: bind (port 4559) already in use; unable to initialize server and I get the password prompt when trying to issue sendfax or faxstat fromt he command line. REgards Helen ************************************************************************ * MKL.Net Internet Service Provider * * A service of CPU Industries * * Bainbridge, New York, USA PPP, dial-up, telnet, uucp, * * http://www.mkl.com virtual domains, web design * * https://mall.mkl.com Secured server - Merchant services * ************************************************************************