![]() |
Rex Fowler wrote: I'm having some problem with alpha paging. The environment is Solaris 2.4 hylafax version hylafax-v4.0pl1 sendpage is hanging apparently right after the 'SEND' command. I'm guessing it has something to do with reading or writing to the FIFO but I'm unsure. Here's a sample telnet sesion with port 444 raptor 956$ telnet localhost 444 Trying 127.0.0.1 ... Connected to localhost. Escape character is '^]'. 220 raptor.mtc.ti.com SNPP server (HylaFAX (tm) Version 4.0pl1) ready. login rmfowler 230 User rmfowler logged in. page rex 500 PAFE: Command not recognized. page rex 250 Pager ID accepted; provider: xxxyyyy pin: wwwzzzz jobid: 40. mess testing telnet 250 Message text OK. send 250 Message processing completed. There is a few minute delay before the '250 Message processing completed' If you don't use the "-q" flag of sendpage(1) (or don't use the "SITE JQUEUE yes" command in the protocol session with telnet) the sendpage(1) will wait for the job delivery to the paging central service. This may take some time (modem dialing and handshaking, error situations etc.). Look into a session log with "tail -f ....." to see what's going on during page delivery. If I interrupt it, I can then use 'pagesend' to send the message successfully. Any ideas of what I can look or if there's more information I can give you. Since pagesend works, I believe the modem and serial port are setup ok. The problem seems to be communication between hfaxd and faxq. Don't think so but you may look into the servertracing with enabled trace for the FIFO messages (0x04000). matthias They 2 processed do share a FIFO, correct? From what I can tell, another FIFO per device is created when using faxgetty, which I'm not currently. Thanks, -- Rex Fowler http://www.mtc.ti.com/~rmfowler (972)997-2779 mailto:rmfowler@mtc.ti.com Alpha Pager http://www.mtc.ti.com/cgi-bin/alpha_pager.cgi TI MSG rfow