Re: hylafax on sgi

[Matthias.Apitz@SOFTCON.de]

D.Hunziker wrote:
    
    I am new using Hylafax.
    I install on SGI Challenge, I got the following message
    
    *************
    
    Warning: /bin/vgetty does not exist or is not an executable program!
    
    The file:
    
        /bin/vgetty
    
    does not exist or this file is not an executable program.  The
    HylaFAX software optionally uses this program and the fact that
    it does not exist on the system is not a fatal error.  If the
    program resides in a different location and you do not want to
    install a symbolic link for /bin/vgetty that points to your program
    then you must reconfigure and rebuild HylaFAX from source code.
    
    
    Warning: /bin/egetty does not exist or is not an executable program!
    
    The file:
    
        /bin/egetty
    
    does not exist or this file is not an executable program.  The
    HylaFAX software optionally uses this program and the fact that
    it does not exist on the system is not a fatal error.  If the
    program resides in a different location and you do not want to
    install a symbolic link for /bin/egetty that points to your program
    then you must reconfigure and rebuild HylaFAX from source code.
    *****************
    
    after this I could configure and add a modem, but faxmodem stops with the
    following message
    *********************
    
    Should I run faxmodem for each configured modem [yes]?
    /usr/local/sbin/faxmodem ttyf2
    
    Done verifying system setup.
    Killed
    ^^^^^^

Did you killed the faxsetup(1M) or is it a message from the proc
itself? If so please run

# sh -x sbin/faxsetup

to see what's going on. If your question is about vgetty/egetty
just search the HylaFAQ for "egetty" (http://www.vix.com/hylafax/FAQ/).

	matthias