HylaFAX The world's
most advanced open source fax server
|
|
[
Date Prev][
Date Next][
Thread Prev][
Thread Next]
[
Date Index]
[
Thread Index]
Re: 1D/2D
In message <199703050020.RAA22562@genie96.com>, Steve Williams writes:
>
>Here is the post that I think you are referring to....however, it only
>mentions receiving, not sending. From the tone of the post, it would
>appear that Multitech is quite cooperative. If TPC.INT has enough
>faxes failing consistently, you should have a bunch of log files to
>give them, once you find the right person to give them to.
This looks like it may be relevant . . . :
---- Transcript of session follows ----
Mar 04 14:39:46.58: [16756]: SESSION BEGIN 00000884 44122727xxxx
Mar 04 14:39:46.58: [16756]: SEND FAX: JOB 20661 DEST +44122727xxxx COMMID
00000884
Mar 04 14:39:46.58: [16756]: DELAY 2600 ms
Mar 04 14:39:51.38: [16756]: <-- [15:ATE0V1X4S0=0H0\r]
Mar 04 14:39:51.49: [16756]: --> [14:ATE0V1X4S0=0H0]
Mar 04 14:39:51.49: [16756]: --> [2:OK]
Mar 04 14:39:51.49: [16756]: <-- [21:ATS8=2S7=60&E4&D3&C1\r]
Mar 04 14:39:51.59: [16756]: --> [2:OK]
Mar 04 14:39:51.59: [16756]: <-- [12:AT+FCLASS=2\r]
Mar 04 14:39:51.71: [16756]: --> [2:OK]
Mar 04 14:39:51.71: [16756]: <-- [10:AT+FTBC=0\r]
Mar 04 14:39:51.81: [16756]: --> [2:OK]
Mar 04 14:39:51.81: [16756]: <-- [10:AT+FBOR=0\r]
Mar 04 14:39:51.91: [16756]: --> [2:OK]
Mar 04 14:39:51.91: [16756]: <-- [13:AT+FPHCTO=60\r]
Mar 04 14:39:52.01: [16756]: --> [2:OK]
Mar 04 14:39:52.01: [16756]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
Mar 04 14:39:52.11: [16756]: --> [2:OK]
Mar 04 14:39:52.11: [16756]: <-- [5:ATM0\r]
Mar 04 14:39:52.21: [16756]: --> [2:OK]
Mar 04 14:39:52.35: [16756]: <-- [12:AT+FCLASS=2\r]
Mar 04 14:39:52.56: [16756]: --> [2:OK]
Mar 04 14:39:52.56: [16756]: <-- [10:AT+FTBC=0\r]
Mar 04 14:39:52.75: [16756]: --> [2:OK]
Mar 04 14:39:52.75: [16756]: <-- [10:AT+FBOR=0\r]
Mar 04 14:39:52.95: [16756]: --> [2:OK]
Mar 04 14:39:52.95: [16756]: <-- [13:AT+FPHCTO=60\r]
Mar 04 14:39:53.15: [16756]: --> [2:OK]
Mar 04 14:39:53.15: [16756]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
Mar 04 14:39:53.35: [16756]: --> [2:OK]
Mar 04 14:39:53.35: [16756]: <-- [29:AT+FLID="Someone Ltd"\r]
Mar 04 14:39:53.55: [16756]: --> [2:OK]
Mar 04 14:39:53.57: [16756]: DIAL 0122727xxxx
Mar 04 14:39:53.57: [16756]: <-- [16:ATDT0122727xxxx\r]
Mar 04 14:40:16.32: [16756]: --> [5:+FCON]
Mar 04 14:40:18.35: [16756]: --> [28:+FCSI:" "]
Mar 04 14:40:18.35: [16756]: REMOTE CSI ""
Mar 04 14:40:18.35: [16756]: --> [21:+FDIS:1,5,0,2,0,0,0,0]
Mar 04 14:40:18.35: [16756]: --> [2:OK]
Mar 04 14:40:18.35: [16756]: REMOTE best rate 14400 bit/s
Mar 04 14:40:18.35: [16756]: REMOTE max page width 1728 pixels in 215 mm
Mar 04 14:40:18.35: [16756]: REMOTE max unlimited page length
Mar 04 14:40:18.35: [16756]: REMOTE best vres 7.7 line/mm
Mar 04 14:40:18.35: [16756]: REMOTE best format 1-D MR
Mar 04 14:40:18.35: [16756]: REMOTE best 0 ms/scanline
Mar 04 14:40:18.35: [16756]: USE 14400 bit/s
Mar 04 14:40:18.35: [16756]: USE 0 ms/scanline
Mar 04 14:40:18.35: [16756]: SEND file "docq/doc31926.ps;41"
Mar 04 14:40:18.38: [16756]: Document was encoded with 2DMR, but client does
not support this data format
Mar 04 14:40:18.38: [16756]: <-- [5:ATH0\r]
Mar 04 14:40:19.99: [16756]: --> [0:]
Mar 04 14:40:19.99: [16756]: MODEM <Empty line>
Mar 04 14:40:20.11: [16756]: SESSION END
-DPN