![]() |
When I attempt a 'sendfax -p -d xxx-xxxxxx' command to retreive a fax from a fax-back service I get the following transcript back. The confusing part is that the 'AT+FSPL=1' command (which seems to be causing the problem) should work with Class 2 modems which both faxaddmodem and probemodem say my modem is - probemodem even says that AT+FSPL is 'OK'! Would be grateful for any hints on what this may be caused by! Is it possible that a modem can be class 2 and NOT offer polling? Regards Hans Christiansen ---- Transcript of session follows ---- Jan 29 17:18:07.38: [11907]: SESSION BEGIN 00001828 14150406131193 Jan 29 17:18:07.39: [11907]: DELAY 2600 ms Jan 29 17:18:09.99: [11907]: <-- [15:ATE0V1Q0S0=0H0\r] Jan 29 17:18:10.14: [11907]: --> [2:OK] Jan 29 17:18:10.14: [11907]: <-- [21:ATS8=2S7=60&K4&D2&C1\r] Jan 29 17:18:10.30: [11907]: --> [2:OK] Jan 29 17:18:10.30: [11907]: <-- [12:AT+FCLASS=2\r] Jan 29 17:18:10.47: [11907]: --> [2:OK] Jan 29 17:18:10.47: [11907]: <-- [10:AT+FTBC=0\r] Jan 29 17:18:10.63: [11907]: --> [2:OK] Jan 29 17:18:10.63: [11907]: <-- [10:AT+FBOR=0\r] Jan 29 17:18:10.78: [11907]: --> [2:OK] Jan 29 17:18:10.78: [11907]: <-- [13:AT+FPHCTO=30\r] Jan 29 17:18:10.94: [11907]: --> [2:OK] Jan 29 17:18:10.94: [11907]: <-- [24:AT+FDCC=1,5,2,2,1,0,0,0\r] Jan 29 17:18:11.10: [11907]: --> [2:OK] Jan 29 17:18:11.10: [11907]: <-- [7:ATL2M1\r] Jan 29 17:18:11.25: [11907]: --> [2:OK] Jan 29 17:18:11.26: [11907]: <-- [12:AT+FCLASS=2\r] Jan 29 17:18:11.49: [11907]: --> [2:OK] Jan 29 17:18:11.49: [11907]: <-- [10:AT+FTBC=0\r] Jan 29 17:18:11.73: [11907]: --> [2:OK] Jan 29 17:18:11.73: [11907]: <-- [10:AT+FBOR=0\r] Jan 29 17:18:11.97: [11907]: --> [2:OK] Jan 29 17:18:11.97: [11907]: <-- [13:AT+FPHCTO=30\r] Jan 29 17:18:12.21: [11907]: --> [2:OK] Jan 29 17:18:12.21: [11907]: <-- [24:AT+FDCC=1,5,2,2,1,0,0,0\r] Jan 29 17:18:12.45: [11907]: --> [2:OK] Jan 29 17:18:12.45: [11907]: <-- [25:AT+FLID="+46.435.000.01"\r] Jan 29 17:18:12.69: [11907]: --> [2:OK] Jan 29 17:18:12.69: [11907]: <-- [10:AT+FSPL=1\r] Jan 29 17:18:12.93: [11907]: --> [5:ERROR] Jan 29 17:18:12.93: [11907]: MODEM Command error Jan 29 17:18:12.94: [11907]: SEND FAILED: Unable to request polling operation (modem may not support polling) Jan 29 17:18:12.94: [11907]: SESSION END hans@ljungbergs.se Ljungbergs Tryckeri AB Tel. +46 435 120 40 Box 100 Fax. +46 435 126 35 S-264 22 Klippan Mob. +46 70 518 26 49 Sweden