Re: [hylafax-users] Adaptive Answer

[Tim Nelson <tnelson@xxxxxxxxxxxxx>]

We've successfully used a product called "The Stick" from Multi-Link that works quite well. Check it out here:

http://www.multi-link.net/index.php?option=com_content&task=view&id=25&Itemid=27

Tim Nelson
Systems/Network Support
Rockbochs Inc.
(218)727-4332

----- Original Message -----
From: "John Squirrell" <john@xxxxxxxxx>
To: hylafax-users@xxxxxxxxxxx
Sent: Thursday, January 10, 2008 8:09:41 AM (GMT-0600) America/Chicago
Subject: [hylafax-users] Adaptive Answer

Hi,

 

I need to run Hylafax from a shared line with my phone.

 

My phone has an ansaphone which picks up after 7 rings.

 

If the incoming transmission is a fax, then I need the fax to be taken by Hylafax.

If the incoming transmission is voice, then I need this to be taken by the phone, and, if I am away, to be taken by the ansaphone.

 

Hylafax v. 4.3.4

SME Server 7.3

Multitech Fax Data Modem MT5600ZDX

The config.ttyS0 file is below

 

If what I want cannot be achieved with the above modem, please suggest a suitable alternative and or correct any errors below.

 

Any help greatly appreciated.

 

Many thanks

 

John

 

DialStringRules:        y
ServerTracing:          1
SessionTracing:         1
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      2
SpeakerVolume:          off
GettyArgs:              "-h %1 dx_%s"
LocalIdentifier:        "John Squirrell"
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              Class1          # use this to supply a hint
ModemRate:              19200           # rate for DCE-DTE communication
ModemFlowControl:       rtscts          # default
#
ModemNoFlowCmd:         AT&K0           # setup no flow control
ModemHardFlowCmd:       AT&K3           # setup hardware flow control
ModemSoftFlowCmd:       AT&K4           # setup software flow control
ModemSetupDTRCmd:       AT&D2           # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier (or not)
#
ModemMfrQueryCmd:       !Rockwell
ModemModelQueryCmd:     !RC288DPi
ModemRevQueryCmd:       ATI3            # product information
#
ModemDialCmd:           ATDT%s          # T for tone dialing
#
AdaptiveAnswer:         yes
AnswerRotary:           "voice fax"
ModemAnswerCmd:         AT+FCLASS0;A
ModemAnswerFaxCmd:      ATH+FCLASS=1;A
Class1RecvIdentTimer:     10000