Re: [hylafax-users] Send fax ERRORS: COMREC invalid response received to PPS - No response to PPS repeated 3 times

[Lee Howard <faxguy@xxxxxxxxxxxxxxxx>]

Luigi Carrieri wrote:

> Apr 06 10:32:50.80: [ 4757]: SEND send PPS (partial page signal)
> Apr 06 10:32:50.80: [ 4757]: SEND send MPS (more pages, same document)
> Apr 06 10:32:51.37: [ 4757]: SEND recv DCN (disconnect)
>  

> Apr 06 10:32:11.56: [ 4488]: No response to PPS repeated 3 times.
>  

> Errors always occur when sending faxes to these Ricoh fax equipments.
> What can I do to correct these errors? Is there anything wrong in modems
> configuration?

As for the DCN after PPS-MPS (the first log).  Does that happen *every* 
time you send *any* fax to this destination?  We've seen at least two 
reports of this kind of thing going on, but we have not been able to 
nail anything down because in the first case that I investigated the 
problem suddenly disappeared on its own, and in the second case the 
reporter never has followed up with test results.

If it is not completely reproducible 100% of the time then please 
determine under what conditions it is at least reliably reproducible, 
and report back.  If you can get it 100% reproducible, then follow these 
steps:

First, call the receiver up and have them reboot their fax machine.  
Then retest.  If it works then report back.  If not, go to the next step.

Second, send them a test fax like this:  echo " " | sendfax -n -F "" -t 
1 -T 1 -d <fax_number>   If it works then report back.  If not then go 
to the next step.

Third, send them a test fax like this:    echo " " | sendfax -1 -n -F "" 
-t 1 -T 1 -d <fax_number>

Fourth, in your modem config file put "ModemSoftRTFCC: no" and then send 
them a test fax like in the third step.

Fifth, send them a test fax like this:  echo " " | sendfax -n -F "" -E 
-t 1 -T 1 -d <fax_number>  Report back.

Hopefully that's enough testing for me to get an idea as far as what's 
going on.

As for the "no response to PPS" error.  Please call the receiver and 
find out if they received any of the page at all.  And if they did, then 
please see if any of the page was missing.  Please report back on that.  
Also, following the steps above would be quite helpful for this case, too.

Thanks,

Lee.

____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*