[hylafax-users] Received fax with a lot of err (see log)

[Anton Setiyono <anton_setiyono@xxxxxxxxxxx>]

Hi,

I'm using SuSE 10.0 with hylafax 4.3.0, I see the log with a lot of 
"COMREC received DCN" and "T.30 T2 timeout, expected page not received" 
and also "T.30 T2 timeout, expected signal not received".

Every 4 from 10 received faxes is either short or not complete. Is there 
anyone having the same problem and how to fix this ? Is my phone line 
not in good condition, or my modem (rockwell K56) using the wrong class 
? Or something else ?

Thank you in advance. Please help.

my config.ttyS0 as follow :
# $Id: conexant-1.0,v 1.2 2006/01/11 17:29:10 lhoward Exp $

#
# Configuration for a Rockwell/Conexant K56 Class 1.0 modem using
# the RCV56DPF and similar chipsets.  These chipsets are generally
# flash- upgradable and appear on ISA as well as PCI.  They
# support "Class 1.0" which means that they have "adaptive receive"
# (AT+FAR=1), but not V.34.
#
#    Comtrol RocketModem II/III
#    MultiTech MT5600ZDX
#    Zoltrix FMVSP56i3
#
#
CountryCode:            61
AreaCode:               221
FAXNumber:              713127
LongDistancePrefix:     0
InternationalPrefix:    001
DialStringRules:        etc/dialrules
ServerTracing:          1
SessionTracing:         11
RecvFileMode:           0600
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "HOME"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
PercentGoodLines:       70
MaxConsecutiveBadLines: 3
MaxRecvPages:           100
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:              Class1.0        # use this to supply a hint
ModemRate:              19200           # rate for DCE-DTE communication
ModemFlowControl:       rtscts          # default
#
ModemNoFlowCmd:         AT&K0           # setup no flow control
ModemHardFlowCmd:       AT&K3           # setup hardware flow control
ModemSoftFlowCmd:       AT&K4           # setup software flow control
ModemSetupDTRCmd:       AT&D2           # setup so DTR drop resets modem
ModemSetupDCDCmd:       AT&C1           # setup so DCD reflects carrier 
(or not)
#
Class1AdaptRecvCmd:     AT+FAR=1        # reports carrier detection 
mismatches

____________________ HylaFAX(tm) Users Mailing List _______________________
 To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
 *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*