[hylafax-users] The full document was not received because: Failed to properly detect high-speed data carrier.

["Thijs" <thijs1@xxxxxxxxx>]

I've set up a faxserver which sends and receives faxes.

 

When receiving faxes i sometimes get the following error:

 

 

recvq/fax000000178.tif (ftp://faxsrv:4559/recvq/fax000000178.tif):
    Sender: 0332217924
     Pages: 1
   Quality: Fine
      Page: 1728 by 196
  Received: 2004:12:14 13:40:05
TimeToRecv: 0:15
SignalRate: 14400 bit/s
DataFormat: 2-D MMR
ErrCorrect: Yes
ReceivedOn: ttyS1

 

The full document was not received because:

 

    Failed to properly detect high-speed data carrier.

 

    ---- Transcript of session follows ----

 

Dec 14 13:39:41.54: [ 8498]: SESSION BEGIN 000000222 310492324326
Dec 14 13:39:41.54: [ 8498]: HylaFAX (tm) Version 4.2.0
Dec 14 13:39:41.54: [ 8498]: <-- [4:ATA\r]
Dec 14 13:39:55.12: [ 8498]: --> [7:CONNECT]
Dec 14 13:39:55.12: [ 8498]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyS1'
Dec 14 13:39:55.12: [ 8498]: RECV FAX: begin
Dec 14 13:39:57.00: [ 8498]: --> [7:CONNECT]
Dec 14 13:39:57.77: [ 8498]: --> [7:CONNECT]
Dec 14 13:39:58.22: [ 8498]: --> [2:OK]
Dec 14 13:39:58.22: [ 8498]: <-- [9:AT+FRH=3\r]
Dec 14 13:39:58.94: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:01.03: [ 8498]: --> [2:OK]
Dec 14 13:40:01.03: [ 8498]: REMOTE TSI "0332217924"
Dec 14 13:40:01.03: [ 8498]: <-- [9:AT+FRH=3\r]
Dec 14 13:40:01.05: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:01.07: [ 8498]: --> [2:OK]
Dec 14 13:40:01.07: [ 8498]: REMOTE wants 14400 bit/s
Dec 14 13:40:01.07: [ 8498]: REMOTE wants A4 page width (215 mm)
Dec 14 13:40:01.07: [ 8498]: REMOTE wants unlimited page length
Dec 14 13:40:01.07: [ 8498]: REMOTE wants 7.7 line/mm
Dec 14 13:40:01.07: [ 8498]: REMOTE wants 2-D MMR
Dec 14 13:40:01.07: [ 8498]: REMOTE wants T.30 Annex A, 256-byte ECM
Dec 14 13:40:01.07: [ 8498]: RECV training at v.17 14400 bit/s
Dec 14 13:40:01.07: [ 8498]: <-- [11:AT+FRM=145\r]
Dec 14 13:40:02.70: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:04.27: [ 8498]: RECV: TCF 2808 bytes, 6% non-zero, 2614 zero-run
Dec 14 13:40:04.27: [ 8498]: --> [10:NO CARRIER]
Dec 14 13:40:04.27: [ 8498]: DELAY 75 ms
Dec 14 13:40:04.35: [ 8498]: TRAINING succeeded
Dec 14 13:40:04.35: [ 8498]: <-- [9:AT+FTH=3\r]
Dec 14 13:40:04.41: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:05.61: [ 8498]: --> [2:OK]
Dec 14 13:40:05.61: [ 8498]: <-- [11:AT+FRM=146\r]
Dec 14 13:40:06.64: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:10.03: [ 8498]: RECV received frame number 0
Dec 14 13:40:10.25: [ 8498]: RECV received frame number 1
Dec 14 13:40:10.40: [ 8498]: RECV received frame number 2
Dec 14 13:40:10.55: [ 8498]: RECV received frame number 3
Dec 14 13:40:10.70: [ 8498]: RECV received frame number 4
Dec 14 13:40:10.86: [ 8498]: RECV received frame number 5
Dec 14 13:40:10.94: [ 8498]: RECV received frame number 6
Dec 14 13:40:11.09: [ 8498]: RECV received frame number 7
Dec 14 13:40:11.31: [ 8498]: RECV received frame number 8
Dec 14 13:40:11.47: [ 8498]: RECV received frame number 9
Dec 14 13:40:11.61: [ 8498]: RECV received frame number 10
Dec 14 13:40:11.77: [ 8498]: RECV received frame number 11
Dec 14 13:40:11.85: [ 8498]: RECV received frame number 12
Dec 14 13:40:12.01: [ 8498]: RECV received frame number 13
Dec 14 13:40:12.16: [ 8498]: RECV received frame number 14
Dec 14 13:40:12.31: [ 8498]: RECV received frame number 15
Dec 14 13:40:12.46: [ 8498]: RECV received frame number 16
Dec 14 13:40:12.62: [ 8498]: RECV received frame number 17
Dec 14 13:40:12.77: [ 8498]: RECV received frame number 18
Dec 14 13:40:12.93: [ 8498]: RECV received frame number 19
Dec 14 13:40:13.09: [ 8498]: RECV received frame number 20
Dec 14 13:40:13.24: [ 8498]: RECV received frame number 21
Dec 14 13:40:13.40: [ 8498]: RECV received frame number 22
Dec 14 13:40:13.56: [ 8498]: RECV received frame number 23
Dec 14 13:40:13.71: [ 8498]: RECV received frame number 24
Dec 14 13:40:13.87: [ 8498]: RECV received frame number 25
Dec 14 13:40:14.02: [ 8498]: RECV received frame number 26
Dec 14 13:40:14.17: [ 8498]: RECV received frame number 27
Dec 14 13:40:14.33: [ 8498]: RECV received frame number 28
Dec 14 13:40:14.47: [ 8498]: RECV received frame number 29
Dec 14 13:40:14.63: [ 8498]: RECV received frame number 30
Dec 14 13:40:14.78: [ 8498]: RECV received frame number 31
Dec 14 13:40:14.86: [ 8498]: RECV received frame number 32
Dec 14 13:40:15.07: [ 8498]: RECV received frame number 33
Dec 14 13:40:15.22: [ 8498]: RECV received frame number 34
Dec 14 13:40:15.36: [ 8498]: RECV received frame number 35
Dec 14 13:40:15.51: [ 8498]: HDLC frame not byte-oriented.  Trailing byte: 0
Dec 14 13:40:15.79: [ 8498]: RECV received frame number 38
Dec 14 13:40:15.93: [ 8498]: RECV received frame number 39
Dec 14 13:40:16.08: [ 8498]: RECV received frame number 40
Dec 14 13:40:16.08: [ 8498]: RECV received RCP frame
Dec 14 13:40:16.22: [ 8498]: --> [10:NO CARRIER]
Dec 14 13:40:16.22: [ 8498]: <-- [9:AT+FRH=3\r]
Dec 14 13:40:16.41: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:17.55: [ 8498]: --> [2:OK]
Dec 14 13:40:17.55: [ 8498]: RECV recv PPS (partial page signal)
Dec 14 13:40:17.55: [ 8498]: RECV recv EOP (no more pages or documents)
Dec 14 13:40:17.55: [ 8498]: RECV received 41 frames of block 1 of page 1
Dec 14 13:40:17.55: [ 8498]: DELAY 70 ms
Dec 14 13:40:17.62: [ 8498]: <-- [9:AT+FTH=3\r]
Dec 14 13:40:17.64: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:19.82: [ 8498]: --> [2:OK]
Dec 14 13:40:19.82: [ 8498]: RECV send PPR (partial page request)
Dec 14 13:40:19.82: [ 8498]: <-- [11:AT+FRM=146\r]
Dec 14 13:40:19.94: [ 8498]: --> [5:ERROR]
Dec 14 13:40:19.94: [ 8498]: RECV keeping unconfirmed page
Dec 14 13:40:19.96: [ 8498]: RECV: 10496 bytes of data, 1513 total lines
Dec 14 13:40:19.96: [ 8498]: RECV FAX (000000222): from 0332217924, page 1 in 0:15, INF, 7.7 line/mm, 2-D MMR, 14400 bit/s
Dec 14 13:40:19.96: [ 8498]: RECV FAX (000000222): recvq/fax000000178.tif from 0332217924, route to <unspecified>, 1 pages in 0:24
Dec 14 13:40:19.96: [ 8498]: RECV FAX: Failed to properly detect high-speed data carrier.
Dec 14 13:40:19.96: [ 8498]: <-- [9:AT+FTH=3\r]
Dec 14 13:40:19.99: [ 8498]: --> [7:CONNECT]
Dec 14 13:40:21.10: [ 8498]: --> [2:OK]
Dec 14 13:40:21.10: [ 8498]: RECV FAX (000000222): session with 0332217924 terminated abnormally: Failed to properly detect high-speed data carrier.
Dec 14 13:40:21.10: [ 8498]: RECV FAX: bin/faxrcvd "recvq/fax000000178.tif" "ttyS1" "000000222" "Failed to properly detect high-speed data carrier." "" ""
Dec 14 13:40:21.10: [ 8498]: RECV FAX: end
Dec 14 13:40:21.10: [ 8498]: SESSION END

 

 

 

 

 

/var/spool/hylafax/etc/config.ttyS1 :

 

ServerTracing:          1
SessionTracing:         11
RecvFileMode:           0666
LogFileMode:            0600
DeviceMode:             0600
RingsBeforeAnswer:      1
SpeakerVolume:          off
GettyArgs:              "-h %l dx_%s"
LocalIdentifier:        "Van Boxtel Software BV"
TagLineFont:            etc/lutRS18.pcf
TagLineFormat:          "From %%l|%c|Page %%P of %%T"
MaxRecvPages:           25
ModemType:              Class1          # hint to override class 2
ModemRate:              19200           # locked for fax sending
ModemFlowControl:       xonxoff         # default
ModemSetupDTRCmd:       AT&D2           # DTR off causes modem to hangup
ModemSetupDCDCmd:       AT&C0           # DCD always on
ModemMfrQueryCmd:       !Nuvo
ModemModelQueryCmd:     !9624PFX
ModemRevQueryCmd:       ATI3
ModemDialCmd:           ATDT%s          # T for tone dialing