[hylafax-users] Receive Black page

["Nicolas Montauban" <nicolas@xxxxxxxxxxx>]

Today I receive a black page. I have no problem since.
This is my log, I dont understand where is the problem.
I'm sure, it is fax of the sender, but nothing appears in log.

How to diagnostic the error ?

Jul 22 14:46:08.29: [ 1240]: SESSION BEGIN 00002507 xxxxxxxxxx
Jul 22 14:46:08.30: [ 1240]: HylaFAX (tm) Version 4.1.6
Jul 22 14:46:08.30: [ 1240]: MODEM set XON/XOFF/FLUSH: input ignored,
output disabled
Jul 22 14:46:08.30: [ 1240]: <-- [4:ATA\r]
Jul 22 14:46:14.36: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:14.37: [ 1240]: ANSWER: FAX CONNECTION  DEVICE '/dev/ttyS0'
Jul 22 14:46:14.37: [ 1240]: MODEM input buffering enabled
Jul 22 14:46:14.37: [ 1240]: RECV FAX: begin
Jul 22 14:46:14.37: [ 1240]: MODEM input buffering disabled
Jul 22 14:46:14.37: [ 1240]: <-- data [23]
Jul 22 14:46:14.37: [ 1240]: <-- data [2]
Jul 22 14:46:16.06: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:16.06: [ 1240]: <-- data [10]
Jul 22 14:46:16.06: [ 1240]: <-- data [2]
Jul 22 14:46:16.59: [ 1240]: --> [2:OK]
Jul 22 14:46:16.59: [ 1240]: <-- [9:AT+FRH=3\r]
Jul 22 14:46:17.00: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:18.43: [ 1240]: --> [2:OK]
Jul 22 14:46:18.43: [ 1240]: REMOTE TSI "xxxxxxxxxx"
Jul 22 14:46:18.43: [ 1240]: <-- [9:AT+FRH=3\r]
Jul 22 14:46:18.45: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:18.70: [ 1240]: --> [2:OK]
Jul 22 14:46:18.70: [ 1240]: REMOTE wants 9600 bit/s
Jul 22 14:46:18.70: [ 1240]: REMOTE wants page width 1728 pixels in 215 mm
Jul 22 14:46:18.70: [ 1240]: REMOTE wants unlimited page length
Jul 22 14:46:18.70: [ 1240]: REMOTE wants 3.85 line/mm
Jul 22 14:46:18.70: [ 1240]: REMOTE wants 2-D MR
Jul 22 14:46:18.70: [ 1240]: RECV training at v.29 9600 bit/s
Jul 22 14:46:18.70: [ 1240]: MODEM set XON/XOFF/DRAIN: input ignored,
output generated
Jul 22 14:46:18.70: [ 1240]: <-- [10:AT+FRM=96\r]
Jul 22 14:46:19.02: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:20.58: [ 1240]: MODEM set XON/XOFF/DRAIN: input ignored,
output disabled
Jul 22 14:46:20.58: [ 1240]: RECV: TCF 1848 bytes, 2% non-zero, 1797 zero-run
Jul 22 14:46:20.59: [ 1240]: --> [10:NO CARRIER]
Jul 22 14:46:20.59: [ 1240]: DELAY 75 ms
Jul 22 14:46:20.67: [ 1240]: TRAINING succeeded
Jul 22 14:46:20.67: [ 1240]: <-- [9:AT+FTH=3\r]
Jul 22 14:46:20.71: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:20.71: [ 1240]: <-- data [3]
Jul 22 14:46:20.71: [ 1240]: <-- data [2]
Jul 22 14:46:22.01: [ 1240]: --> [2:OK]
Jul 22 14:46:22.01: [ 1240]: MODEM input buffering enabled
Jul 22 14:46:22.01: [ 1240]: MODEM set XON/XOFF/FLUSH: input ignored,
output generated
Jul 22 14:46:22.01: [ 1240]: <-- [10:AT+FRM=96\r]
Jul 22 14:46:22.50: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:22.50: [ 1240]: RECV: begin page
Jul 22 14:46:50.08: [ 1240]: RECV: 2120 total lines, 0 bad lines, 0
consecutive bad lines
Jul 22 14:46:50.08: [ 1240]: RECV: end page
Jul 22 14:46:50.08: [ 1240]: --> [10:NO CARRIER]
Jul 22 14:46:50.08: [ 1240]: MODEM set XON/XOFF/DRAIN: input ignored,
output disabled
Jul 22 14:46:50.08: [ 1240]: MODEM input buffering disabled
Jul 22 14:46:50.08: [ 1240]: <-- [9:AT+FRH=3\r]
Jul 22 14:46:50.46: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:51.22: [ 1240]: --> [2:OK]
Jul 22 14:46:51.22: [ 1240]: RECV recv EOP (no more pages or documents)
Jul 22 14:46:51.22: [ 1240]: <-- [9:AT+FRS=7\r]
Jul 22 14:46:51.34: [ 1240]: --> [2:OK]
Jul 22 14:46:51.34: [ 1240]: <-- [9:AT+FTH=3\r]
Jul 22 14:46:51.38: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:51.38: [ 1240]: <-- data [3]
Jul 22 14:46:51.38: [ 1240]: <-- data [2]
Jul 22 14:46:52.68: [ 1240]: --> [2:OK]
Jul 22 14:46:52.68: [ 1240]: RECV send MCF (message confirmation)
Jul 22 14:46:52.68: [ 1240]: RECV FAX (00002507): from xxxxxxxxxx, page 1
in 0:32, INF, 3.85 line/mm, 2-D MR, 9600 bit/s
Jul 22 14:46:52.68: [ 1240]: RECV FAX (00002507): recvq/fax02257.tif from
xxxxxxxxxx, route to <unspecified>, 1 pages in 0:38
Jul 22 14:46:52.68: [ 1240]: <-- [9:AT+FRH=3\r]
Jul 22 14:46:53.10: [ 1240]: --> [7:CONNECT]
Jul 22 14:46:53.98: [ 1240]: --> [2:OK]
Jul 22 14:46:53.98: [ 1240]: MODEM input buffering enabled
Jul 22 14:46:53.98: [ 1240]: RECV FAX: bin/faxrcvd "recvq/fax02257.tif"
"ttyS0" "00002507" "" "" ""
Jul 22 14:46:54.21: [ 1240]: RECV FAX: end
Jul 22 14:46:54.21: [ 1240]: SESSION END


____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*