Re: [hylafax-users] NO CARRIER - ZYXEL Omni 56k Modem - Fedora Linux - Latest Hylafax

["Y BAESA" <ybaesa@xxxxxxxxxx>]

Hello,

Try to use a config of ZyXel which is under../config of Hylafax

personally I use the config Zyxel-1496e-1 with a zyxel U-90e

 that must function

 

Yves

----- Original Message -----

From: Godfrey Lawrence

To: hylafax-users@xxxxxxxxxxx

Sent: Thursday, February 19, 2004 1:59 PM

Subject: [hylafax-users] NO CARRIER - ZYXEL Omni 56k Modem - Fedora Linux - Latest Hylafax

hello world,
 
greetings!
 
Modem :- ZYXEL Omni 56k Modem -
Linux  :-Redhat  Fedora
Latest Hylafax s/w from hylafax.org
 
 
guys i am getting the following log while trying to receive the fax !can anyone help me?
 
 
Feb 19 13:16:59.12: [ 3477]: SESSION BEGIN 00000031 910805542304
Feb 19 13:16:59.12: [ 3477]: HylaFAX (tm) Version 4.1.8
Feb 19 13:16:59.12: [ 3477]: <-- [4:ATA\r]
Feb 19 13:17:06.05: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:06.05: [ 3477]: ANSWER: FAX CONNECTION  DEVICE '/dev/cua1'
Feb 19 13:17:06.05: [ 3477]: RECV FAX: begin
Feb 19 13:17:06.17: [ 3477]: <-- data [23]
Feb 19 13:17:06.17: [ 3477]: <-- data [2]
Feb 19 13:17:07.18: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:07.18: [ 3477]: <-- data [10]
Feb 19 13:17:07.18: [ 3477]: <-- data [2]
Feb 19 13:17:07.62: [ 3477]: --> [2:OK]
Feb 19 13:17:07.62: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:10.72: [ 3477]: --> [0:]
Feb 19 13:17:10.72: [ 3477]: MODEM <Empty line>
Feb 19 13:17:10.72: [ 3477]: <-- data [1]
Feb 19 13:17:10.73: [ 3477]: --> [2:OK]
Feb 19 13:17:10.73: [ 3477]: DELAY 1500 ms
Feb 19 13:17:12.23: [ 3477]: <-- [9:AT+FTH=3\r]
Feb 19 13:17:13.27: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:13.27: [ 3477]: <-- data [23]
Feb 19 13:17:13.27: [ 3477]: <-- data [2]
Feb 19 13:17:14.29: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:14.29: [ 3477]: <-- data [10]
Feb 19 13:17:14.29: [ 3477]: <-- data [2]
Feb 19 13:17:14.72: [ 3477]: --> [2:OK]
Feb 19 13:17:14.72: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:15.25: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:16.78: [ 3477]: --> [2:OK]
Feb 19 13:17:16.78: [ 3477]: REMOTE TSI "080"
Feb 19 13:17:16.78: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:16.82: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:17.04: [ 3477]: --> [2:OK]
Feb 19 13:17:17.04: [ 3477]: REMOTE wants 9600 bit/s
Feb 19 13:17:17.04: [ 3477]: REMOTE wants page width 1728 pixels in 215 mm
Feb 19 13:17:17.04: [ 3477]: REMOTE wants unlimited page length
Feb 19 13:17:17.04: [ 3477]: REMOTE wants 3.85 line/mm
Feb 19 13:17:17.04: [ 3477]: REMOTE wants 2-D MR
Feb 19 13:17:17.04: [ 3477]: RECV training at v.29 9600 bit/s
Feb 19 13:17:17.04: [ 3477]: <-- [10:AT+FRM=96\r]
Feb 19 13:17:17.39: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:18.90: [ 3477]: RECV: TCF 1868 bytes, 0% non-zero, 1800 zero-run
Feb 19 13:17:18.91: [ 3477]: --> [10:NO CARRIER]
Feb 19 13:17:18.91: [ 3477]: DELAY 75 ms
Feb 19 13:17:18.99: [ 3477]: TRAINING succeeded
Feb 19 13:17:18.99: [ 3477]: <-- [9:AT+FTH=3\r]
Feb 19 13:17:20.13: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:20.13: [ 3477]: <-- data [3]
Feb 19 13:17:20.13: [ 3477]: <-- data [2]
Feb 19 13:17:20.37: [ 3477]: --> [2:OK]
Feb 19 13:17:20.37: [ 3477]: <-- [10:AT+FRM=96\r]
Feb 19 13:17:20.97: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:20.97: [ 3477]: RECV: begin page
Feb 19 13:17:39.00: [ 3477]: RECV: 817 total lines, 0 bad lines, 0 consecutive bad lines
Feb 19 13:17:39.00: [ 3477]: RECV: end page
Feb 19 13:17:39.00: [ 3477]: --> [10:NO CARRIER]
Feb 19 13:17:39.00: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:39.24: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:40.20: [ 3477]: --> [2:OK]
Feb 19 13:17:40.20: [ 3477]: HDLC frame too short (3 bytes)
Feb 19 13:17:40.20: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:40.24: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:40.25: [ 3477]: --> [10:NO CARRIER]
Feb 19 13:17:40.25: [ 3477]: MODEM No carrier
Feb 19 13:17:40.25: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:43.33: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:44.53: [ 3477]: --> [2:OK]
Feb 19 13:17:44.53: [ 3477]: HDLC frame too short (3 bytes)
Feb 19 13:17:44.53: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:44.57: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:44.59: [ 3477]: --> [10:NO CARRIER]
Feb 19 13:17:44.59: [ 3477]: MODEM No carrier
Feb 19 13:17:44.59: [ 3477]: <-- [9:AT+FRH=3\r]
Feb 19 13:17:47.66: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:48.86: [ 3477]: --> [2:OK]
Feb 19 13:17:48.86: [ 3477]: HDLC frame too short (3 bytes)
Feb 19 13:17:49.11: [ 3477]: RECV FAX (00000031): recvq/fax00009.tif from 080, route to <unspecified>, 0 pages in 0:43
Feb 19 13:17:49.11: [ 3477]: RECV FAX: T.30 T2 timeout, expected page not received
Feb 19 13:17:49.11: [ 3477]: <-- [9:AT+FTH=3\r]
Feb 19 13:17:50.15: [ 3477]: --> [7:CONNECT]
Feb 19 13:17:50.15: [ 3477]: <-- data [3]
Feb 19 13:17:50.15: [ 3477]: <-- data [2]
Feb 19 13:17:50.39: [ 3477]: --> [2:OK]
Feb 19 13:17:50.39: [ 3477]: RECV FAX (00000031): session with 080 terminated abnormally: T.30 T2 timeout, expected page not received
Feb 19 13:17:50.39: [ 3477]: RECV FAX: bin/faxrcvd "recvq/fax00009.tif" "cua1" "00000031" "T.30 T2 timeout, expected page not received" "" ""
Feb 19 13:18:11.38: [ 3477]: RECV FAX: end
Feb 19 13:18:11.38: [ 3477]: SESSION END

 

regards

lawrence

 

---

Do you Yahoo!?
Yahoo! Mail SpamGuard - Read only the mail you want.