HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [hylafax-users] Blocking calls based on DNIS/DID



Lee,

Thanks again for your reply.  It seems that the man
pages I was reading (the ones on the Hylafax.org
website) are a bit dated! ;-)

I had not downloaded the packages yet, since I was
still in the discovery phase.  I did so, and installed
the software (although I have not procured the modem
card as of yet), so now I have access to all the
manual entries.

This (along with my other work) should keep me busy
for a little while, so I will not be bothering you
quite as often.

Thanks again.
Mazi.


--- Lee Howard <faxguy@howardsilvan.com> wrote:
> On 2003.08.08 16:38 mazi farhang wrote:
> 
> > In reading through the documentation and the
> mailing
> > lists, I only saw how blocking would be
> accomplished
> > based on Caller ID and/or sending fax machine ID.
> 
> It depends on what documentation you read.  HylaFAX
> has been around a 
> while and DID support is relatively new.  Because
> DID is (when useful) 
> presented to HylaFAX very similar to the way that
> CID is, DID support 
> is wrapped up with CID support.  In other words 'man
> cid' and 'man 
> hylafax-config' under "QualifyCID", "CIDName", and
> "CIDNumber" are your 
> friends.  All of those should not be
> Caller-ID-specific.
> 
> > I
> > would assume that the first may be possible
> without
> > answering the call, but not the second.
> 
> Correct, the call must be answered to get TSI.
> 
> > In my case, I am trying to block a call based on
> > DNIS/DID.  I could not find any info on DNIS/DID,
> > except how to route a fax once it has been
> received
> > based on these values.
> 
> If you can configure it to route a fax based on DID
> then you can also 
> block by it because your QualifyCID (etc/cid) file
> must be configured 
> for it to work.
> 
> > Please be kind enough to point
> > me in the right direction so that I know where to
> > look.
> 
> Any current HylaFAX documentation you read on CID
> also applies to DID.  
> Start with 'man cid'.
> 
> > Also, if you have any technical reasons for
> > choosing DNIS over DID (or vice versa), I would
> > appreciate hearing about it, so that we could
> bring
> > that into the decision making process.
> 
> I'm not the one to answer that, sorry.
> 
> Lee.


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com

____________________ HylaFAX(tm) Users Mailing List _______________________
  To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
 On UNIX: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null
  *To learn about commercial HylaFAX(tm) support, mail sales@hylafax.org.*




Project hosted by iFAX Solutions