I have just installed hylafax to be used to receive faxes and am using
the config below:
USR V.everything / Solaris 8 / Hylafax 4.1.6
I set up the modem as a class 2.0 modem and accepted the default
settings. It answers the call, but then aborts. The fax machine I
am testing it on (a Brother) complains about poor line condition. Also,
I dont seem to be able to get debug messages in my syslog dump - I set it up
as per the instructions on the hylafax documentation but I just seem to be
getting info type messages ..(?).
Any one else out there get this configuration going ?
thanks
:^)
A l R a n k i n
S y s t e m A d m i n
AGFA PACS
AGFA Web1000
Cerner QuadRIS
This email message may contain confidential information and is
intended only for the individual named. If you are not the named
addressee you should not disseminate, distribute or copy this email.
Please notify the sender immediately by email if you have received this
email by mistake and delete this email from your system. Email
transmissions cannot be guaranteed to be secure or error free as
information could be intercepted, corrupted, lost, destroyed, arrive
late or incomplete, or contain viruses. The sender therefore does not
accept any liability for errors or omissions in the contents of this
message that arise as a result of email transmissions. If verification
is required please request a hard copy version.
| |