Re: [hylafax-users] using pause(xx) in etc/config

[Giulio Orsero <giulioo@pobox.com>]

On Thu, 22 Nov 2001 19:55:55 +0100, you wrote:

>Now that bugzilla is up, I found out how to do it:
>Class1TCFWaitCmd: "<delay:7>"    (to delay 70msec)
>http://bugs.hylafax.org/bugzilla/show_bug.cgi?id=197
>I tried it and it works!

Just for the record, I never reads the manpage enough...

hylafax-config

===
 and wait for a specific response from the modem.  The fol­
       lowing escape codes are interpreted:
              Escape      Effect
              <none>      enable no flow control between DTE and DCE
              <xon>       enable software flow control between DTE and DCE
              <rts>       enable hardware flow control between DTE and DCE
              <2400>      set the DCE-DTE baud rate to 2400 bps
              <4800>      set the DCE-DTE baud rate to 4800 bps
              <9600>      set the DCE-DTE baud rate to 9600 bps
              <19200>     set the DCE-DTE baud rate to 19200 bps
              <38400>     set the DCE-DTE baud rate to 38400 bps
              <57600>     set the DCE-DTE baud rate to 57600 bps
              <76800>     set the DCE-DTE baud rate to 76800 bps
              <115200>    set the DCE-DTE baud rate to 115200 bps
              <delay:N>   delay N x 10 ms on the host (0 <= N <= 255)
              <flush>     flush any pending input data from the modem
              <waitfor:R> wait for the response R from the modem (see below)
===

-- 
giulioo@pobox.com


____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null