HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

[hylafax-users] Fw: facsimile job 2441 to 3569273 failed



This log info might help to determine the problem as well. It includes stuff at the end that was not in the original attachment I sent.
 
----- Original Message -----
From: Fax Master
To: warren@bandm.co.nz
Sent: Friday, August 17, 2001 2:09 PM
Subject: facsimile job 2441 to 3569273 failed

Your facsimile job to 3569273 failed because:
    Unable to transmit page (giving up after 3 attempts); too many attempts to send

    ---- Transcript of session follows ----

Aug 17 14:07:06.34: [20496]: SESSION BEGIN 00003832 6463569273
Aug 17 14:07:06.34: [20496]: SEND FAX: JOB 2441 DEST 3569273 COMMID 00003832
Aug 17 14:07:06.34: [20496]: MODEM set DTR OFF
Aug 17 14:07:06.34: [20496]: DELAY 2600 ms
Aug 17 14:07:08.94: [20496]: MODEM set DTR ON
Aug 17 14:07:08.94: [20496]: MODEM set baud rate: 38400 baud, input flow RTS/CTS, output flow RTS/CTS
Aug 17 14:07:08.94: [20496]: MODEM flush i/o
Aug 17 14:07:08.94: [20496]: <-- [15:ATE0V1Q0S0=0H0\r]
Aug 17 14:07:09.08: [20496]: --> [2:OK]
Aug 17 14:07:09.08: [20496]: <-- [21:ATS8=2S7=60&K3&D3&C1\r]
Aug 17 14:07:09.23: [20496]: --> [2:OK]
Aug 17 14:07:09.23: [20496]: <-- [12:AT+FCLASS=2\r]
Aug 17 14:07:09.37: [20496]: --> [2:OK]
Aug 17 14:07:09.37: [20496]: <-- [10:AT+FTBC=0\r]
Aug 17 14:07:09.51: [20496]: --> [2:OK]
Aug 17 14:07:09.51: [20496]: <-- [10:AT+FBOR=0\r]
Aug 17 14:07:09.65: [20496]: --> [2:OK]
Aug 17 14:07:09.65: [20496]: <-- [13:AT+FPHCTO=30\r]
Aug 17 14:07:09.79: [20496]: --> [2:OK]
Aug 17 14:07:09.79: [20496]: <-- [10:AT+FBUG=1\r]
Aug 17 14:07:09.93: [20496]: --> [5:ERROR]
Aug 17 14:07:09.93: [20496]: MODEM Command error
Aug 17 14:07:09.93: [20496]: <-- [24:AT+FDCC=1,5,2,2,1,0,0,0\r]
Aug 17 14:07:10.08: [20496]: --> [2:OK]
Aug 17 14:07:10.08: [20496]: <-- [7:ATL0M1\r]
Aug 17 14:07:10.22: [20496]: --> [2:OK]
Aug 17 14:07:10.22: [20496]: STATE CHANGE: RUNNING -> SENDING
Aug 17 14:07:10.22: [20496]: MODEM input buffering enabled
Aug 17 14:07:10.22: [20496]: <-- [12:AT+FCLASS=2\r]
Aug 17 14:07:10.46: [20496]: --> [2:OK]
Aug 17 14:07:10.46: [20496]: <-- [10:AT+FTBC=0\r]
Aug 17 14:07:10.70: [20496]: --> [2:OK]
Aug 17 14:07:10.70: [20496]: <-- [10:AT+FBOR=0\r]
Aug 17 14:07:10.94: [20496]: --> [2:OK]
Aug 17 14:07:10.94: [20496]: <-- [13:AT+FPHCTO=30\r]
Aug 17 14:07:11.18: [20496]: --> [2:OK]
Aug 17 14:07:11.18: [20496]: <-- [10:AT+FBUG=1\r]
Aug 17 14:07:11.42: [20496]: --> [5:ERROR]
Aug 17 14:07:11.42: [20496]: MODEM Command error
Aug 17 14:07:11.42: [20496]: <-- [24:AT+FDCC=1,5,2,2,1,0,0,0\r]
Aug 17 14:07:11.67: [20496]: --> [2:OK]
Aug 17 14:07:11.67: [20496]: <-- [22:AT+FLID="B & M GROUP"\r]
Aug 17 14:07:11.92: [20496]: --> [2:OK]
Aug 17 14:07:11.95: [20496]: DIAL 3569273
Aug 17 14:07:11.95: [20496]: <-- [12:ATDT3569273\r]
Aug 17 14:07:25.40: [20496]: --> [5:+FCON]
Aug 17 14:07:28.03: [20496]: --> [29:+FCSI: "        64 6 3569273"]
Aug 17 14:07:28.03: [20496]: REMOTE CSI "64 6 3569273"
Aug 17 14:07:28.45: [20496]: --> [22:+FDIS: 1,5,0,2,1,0,0,2]
Aug 17 14:07:28.45: [20496]: --> [2:OK]
Aug 17 14:07:28.45: [20496]: REMOTE best rate 14400 bit/s
Aug 17 14:07:28.45: [20496]: REMOTE max page width 1728 pixels in 215 mm
Aug 17 14:07:28.45: [20496]: REMOTE max unlimited page length
Aug 17 14:07:28.45: [20496]: REMOTE best vres 7.7 line/mm
Aug 17 14:07:28.45: [20496]: REMOTE best format 2-D MR
Aug 17 14:07:28.45: [20496]: REMOTE best 10 ms, 5 ms/scanline
Aug 17 14:07:28.45: [20496]: USE 14400 bit/s
Aug 17 14:07:28.45: [20496]: USE 10 ms, 5 ms/scanline
Aug 17 14:07:28.45: [20496]: SEND file "docq/doc2441.cover;40"
Aug 17 14:07:28.45: [20496]: USE page width 1728 pixels in 215 mm
Aug 17 14:07:28.45: [20496]: USE unlimited page length
Aug 17 14:07:28.45: [20496]: USE 3.85 line/mm
Aug 17 14:07:28.45: [20496]: USE 2-D MR
Aug 17 14:07:28.45: [20496]: <-- [24:AT+FDIS=0,5,0,2,1,0,0,2\r]
Aug 17 14:07:28.71: [20496]: --> [2:OK]
Aug 17 14:07:28.71: [20496]: <-- [7:AT+FDT\r]
Aug 17 14:07:36.73: [20496]: --> [22:+FDCS: 0,5,0,2,1,0,0,3]
Aug 17 14:07:36.73: [20496]: --> [7:CONNECT]
Aug 17 14:07:36.73: [20496]: SEND wait for XON
Aug 17 14:07:36.73: [20496]: --> [1:]
Aug 17 14:07:36.73: [20496]: SEND begin page
Aug 17 14:07:41.18: [20496]: SENT 8338 bytes of data
Aug 17 14:07:41.19: [20496]: SEND end page
Aug 17 14:07:52.02: [20496]: --> [2:OK]
Aug 17 14:07:52.02: [20496]: SEND send MPS (more pages, same document)
Aug 17 14:07:52.02: [20496]: <-- [9:AT+FET=0\r]
Aug 17 14:07:59.20: [20496]: --> [8:+FPTS: 2]
Aug 17 14:07:59.20: [20496]: --> [2:OK]
Aug 17 14:07:59.20: [20496]: SEND recv RTN (retrain negative)
Aug 17 14:07:59.20: [20496]: <-- [7:AT+FDT\r]
Aug 17 14:08:07.03: [20496]: --> [22:+FDCS: 0,5,0,2,1,0,0,3]
Aug 17 14:08:07.03: [20496]: --> [7:CONNECT]
Aug 17 14:08:07.03: [20496]: SEND wait for XON
Aug 17 14:08:07.03: [20496]: --> [1:]
Aug 17 14:08:07.03: [20496]: SEND begin page
Aug 17 14:08:11.49: [20496]: SENT 8338 bytes of data
Aug 17 14:08:11.49: [20496]: SEND end page
Aug 17 14:08:22.33: [20496]: --> [2:OK]
Aug 17 14:08:22.33: [20496]: SEND send MPS (more pages, same document)
Aug 17 14:08:22.33: [20496]: <-- [9:AT+FET=0\r]
Aug 17 14:08:29.41: [20496]: --> [8:+FPTS: 2]
Aug 17 14:08:29.52: [20496]: --> [2:OK]
Aug 17 14:08:29.52: [20496]: SEND recv RTN (retrain negative)
Aug 17 14:08:29.52: [20496]: <-- [7:AT+FDT\r]
Aug 17 14:08:37.34: [20496]: --> [22:+FDCS: 0,5,0,2,1,0,0,3]
Aug 17 14:08:37.34: [20496]: --> [7:CONNECT]
Aug 17 14:08:37.34: [20496]: SEND wait for XON
Aug 17 14:08:37.34: [20496]: --> [1:]
Aug 17 14:08:37.34: [20496]: SEND begin page
Aug 17 14:08:41.80: [20496]: SENT 8338 bytes of data
Aug 17 14:08:41.80: [20496]: SEND end page
Aug 17 14:08:52.64: [20496]: --> [2:OK]
Aug 17 14:08:52.64: [20496]: SEND send MPS (more pages, same document)
Aug 17 14:08:52.64: [20496]: <-- [9:AT+FET=0\r]
Aug 17 14:08:59.72: [20496]: --> [8:+FPTS: 2]
Aug 17 14:08:59.83: [20496]: --> [2:OK]
Aug 17 14:08:59.83: [20496]: SEND recv RTN (retrain negative)
Aug 17 14:08:59.83: [20496]: <-- [6:AT+FK\r]
Aug 17 14:09:05.47: [20496]: --> [9:+FHNG: 50]
Aug 17 14:09:05.47: [20496]: REMOTE HANGUP: Unspecified Transmit Phase D error, including +FPHCTO timeout between data and +FET command (code 50)
Aug 17 14:09:06.11: [20496]: --> [2:OK]
Aug 17 14:09:06.11: [20496]: SEND FAILED: Unable to transmit page (giving up after 3 attempts); too many attempts to send
Aug 17 14:09:06.11: [20496]: <-- [5:ATH0\r]
Aug 17 14:09:06.35: [20496]: --> [2:OK]
Aug 17 14:09:06.35: [20496]: MODEM set DTR OFF
Aug 17 14:09:06.35: [20496]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5)
Aug 17 14:09:06.35: [20496]: SESSION END

    ---- Unsent job status ----

   Destination: 3569273
         JobID: 2441
       GroupID: 2441
        Sender: warren
      Mailaddr: warren@bandm.co.nz
        CommID: 00003832
Submitted From: as
    Page Width: 194 (mm)
   Page Length: 281 (mm)
    Resolution: 98 (lpi)
        Status: Unable to transmit page (giving up after 3 attempts); too many attempts to send
       Dialogs: 1 (exchanges with remote device)
         Dials: 0 (consecutive failed calls to destination)
         Calls: 1 (total phone calls placed)
         Pages: 0 (pages transmitted)
      TotPages: 2 (total pages to transmit)
      Attempts: 1 (attempts to send current page)
        Dirnum: 0 (directory of next page to send)

    ---- Documents submitted for transmission ----

The following documents were submitted for transmission and are
available on the server for reuse until they are automatically
purged when this job is removed.  Documents may also be manually
removed using the faxrm command; consult faxrm(1) for information.

Filename                 Size Type
docq/doc2441.cover          0 PostScript cover page
docq/doc4437.ps             0 PostScript


***************************************************
This email and any files sent with it are confidential and intended solely for the use
of the individual or entity to which they are addressed.

If you have received this message in error, please advise the sender.

This footnote also confirms that all e-mail messages and attachments sent to
or by the B&M Group are scanned for viruses for your safety by Mailscan..

www.mailscan.deerfield.com

*******************************************************************




Project hosted by iFAX Solutions