[hylafax-users] receiving 1-D MR-coded faxes incomplete

[Guido Schmidt <webmaster@schalloch.de>]

I installed HylaFax 4.1beta2 on SuSE 6.4 using a Zyxel U1496 E+ with firmware
6.22 (configured as CLASS=2.0). Every incoming fax is received without error
messages, but if the sender uses 1-D MR-coded (see  log-file below) the
resulting document contains only the first few lines (where the sending
fax-machine usually places its faxnumber, ID, date and page counter). 2-D
MR-coded faxes don` t show any problems.


SESSION BEGIN 00000003 49404302947
<-- [4:ATA\r]
--> [11:CONNECT FAX]
ANSWER: FAX CONNECTION
MODEM input buffering enabled
RECV FAX: begin
--> [4:+FCO]
--> [26:+FTI:     +49 37422 55599 ]
REMOTE TSI "+49 37422 55599"
--> [20:+FCS:1,5,0,2,0,0,0,0]
REMOTE wants 14400 bit/s
REMOTE wants page width 1728 pixels in 215 mm
REMOTE wants unlimited page length 
REMOTE wants 7.7 line/mm
REMOTE wants 1-D MR
--> [2:OK]
<-- [7:AT+FDR\r]
--> [20:+FCS:1,5,0,2,0,0,0,0]
REMOTE wants 14400 bit/s
REMOTE wants page width 1728 pixels in 215 mm
REMOTE wants unlimited page length 
FREMOTE wants 7.7 line/mm
REMOTE wants 1-D MR
--> [7:CONNECT]
RECV: begin page
RECV: send trigger 022
<-- data [1]
RECV: 2025 bytes of data, 39 total lines
--> [16:+FPS:1,945,1,0,0]
--> [6:+FET:2]
RECV recv EOP (no more pages or documents)
--> [2:OK]
RECV send MCF (message confirmation)
RECV FAX (00000003): from +49 37422 55599, page 1 in 2:01, INF, 7.7 line/mm, 1-D MR
RECV FAX (00000003): recvq/fax00032.tif from +49 37422 55599, route to <unspecified>, 1 pages in 2:05
<-- [7:AT+FDR\r]
--> [7:+FHS:00]
REMOTE HANGUP: Normal and proper end of connection (code 0)
RECV FAX: bin/faxrcvd "recvq/fax00032.tif" "ttyS1" "00000003" ""
RECV FAX: end
SESSION END


____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null