flexfax: sendpage returns error even though page has been sent

["Gerald Kowalsky" <gerry@wincom.net>]

Hello,

I'm trying to debug an error with a specific paging provider (Bell Mobility
Canada.)  I'm running the binary distribution hylafax-4.0pl2-3rh5 on a
RedHat6.1 i386 box.  Other providers work as expected.

It doesn't appear that the provider is sending appropriate responses.  With
all "successful" pages I get the error e-mail indicating the following:

    ---- Unsent job status ----

   Destination: 371978
         JobID: 984
       GroupID: 984
        Sender: gerry
      Mailaddr: gerry@wincom.net
        CommID: 00000136
Submitted From: mail.wincom.net
        Status: Job has no PIN to send to
       Dialogs: 1 (exchanges with remote device)
         Dials: 0 (consecutive failed calls to destination)
         Calls: 1 (total phone calls placed)

    ---- Message text ----

The SessionTrace follows

Apr 28 17:47:06.31: [ 6357]: SESSION BEGIN 00000136 15192528222
Apr 28 17:47:06.32: [ 6357]: SEND PAGE: JOB 984 DEST 2528222 COMMID 00000136
Apr 28 17:47:06.33: [ 6357]: MODEM set DTR OFF
Apr 28 17:47:06.33: [ 6357]: DELAY 2600 ms
Apr 28 17:47:08.93: [ 6357]: MODEM set DTR ON
Apr 28 17:47:08.93: [ 6357]: MODEM set baud rate: 38400 baud, input flow
RTS/CTS, output flow RTS/CTS
Apr 28 17:47:08.93: [ 6357]: MODEM flush i/o
Apr 28 17:47:08.93: [ 6357]: <-- [15:ATE0V1Q0S0=0H0\r]
Apr 28 17:47:09.77: [ 6357]: --> [2:OK]
Apr 28 17:47:09.77: [ 6357]: <-- [27:ATS8=2S7=60&R0\D1\Q3&D2&C1\r]
Apr 28 17:47:09.92: [ 6357]: --> [2:OK]
Apr 28 17:47:09.92: [ 6357]: <-- [5:ATM0\r]
Apr 28 17:47:10.06: [ 6357]: --> [2:OK]
Apr 28 17:47:10.06: [ 6357]: MODEM set parity: 7 bits, even parity
Apr 28 17:47:10.06: [ 6357]: MODEM input buffering enabled
Apr 28 17:47:10.06: [ 6357]: <-- [12:AT+FCLASS=0\r]
Apr 28 17:47:10.31: [ 6357]: --> [2:OK]
Apr 28 17:47:10.31: [ 6357]: <-- [8:AT%B300\r]
Apr 28 17:47:10.55: [ 6357]: --> [2:OK]
Apr 28 17:47:10.55: [ 6357]: DIAL 2528222
Apr 28 17:47:10.55: [ 6357]: <-- [13:ATDT92528222\r]
Apr 28 17:47:22.21: [ 6357]: --> [11:CONNECT 300]
Apr 28 17:47:22.21: [ 6357]: EXPECT ID (paging central identification)
Apr 28 17:47:24.21: [ 6357]: MODEM TIMEOUT: reading line from modem
Apr 28 17:47:24.84: [ 6357]: RECV ID ("ID=")
Apr 28 17:47:24.84: [ 6357]: SEND device identification/login request
Apr 28 17:47:26.36: [ 6357]: RECV ACK (login successful)
Apr 28 17:47:26.93: [ 6357]: RECV go-ahead (prologue done)
Apr 28 17:47:26.93: [ 6357]: SEND message block
Apr 28 17:47:30.90: [ 6357]: RECV ACK (message block accepted)
Apr 28 17:47:32.83: [ 6357]: RECV:  1 Page Sent   Good Bye
Apr 28 17:47:34.91: [ 6357]: RECVunknown paging central response:
pr 28 17:47:34.91: [ 6357]: RECV: NO CARRIER
Apr 28 17:48:04.91: [ 6357]: MODEM TIMEOUT: reading line from modem
Apr 28 17:48:04.91: [ 6357]: <-- [5:ATH0\r]
Apr 28 17:48:05.85: [ 6357]: --> [2:OK]
Apr 28 17:48:05.85: [ 6357]: MODEM input buffering enabled
Apr 28 17:48:05.85: [ 6357]: MODEM set DTR OFF
Apr 28 17:48:05.85: [ 6357]: SESSION END