Re: flexfax: Problem with Faxsending

[Ingo Wilmer <wilmer@zeitspringer.de>]

> I think it a problem of flow control. Which modem do you
> have? Send your config.modem (please delete prosa text).
> 
> Ekkard
Hello Ekkard,
speaking for myself, yes, I got this error with every fax i tried to
send, no matter if send local from the server or via whfc or Susefax.
Enclosed you will find my config.file:
Class2Cmd:		AT+FCLASS=2.0	# command to enter class 2.0
Class2BORCmd:		AT+FBO=0	# bit order for phase B/C/D (direct)
Class2CQCmd:		""		# commands to enable copy quality proc.
Class2AbortCmd:		AT+FKS		# abort session command
Class2CQQueryCmd:	AT+FCQ=?	# query for copy quality capabilities
Class2DCCQueryCmd:	AT+FCC=?	# query for modem capabilities
Class2TBCCmd:		AT+FPP=0	# setup stream mode
Class2CRCmd:		AT+FCR=1	# enable capability to receive
Class2PHCTOCmd:		AT+FCT=30	# set phase C timeout parameter
Class2BUGCmd:		AT+FBU=1	# enable HDLC frame tracing
Class2LIDCmd:		AT+FLI		# set local identifier command
Class2DCCCmd:		AT+FCC		# set modem capabilities command
Class2DISCmd:		AT+FIS		# set session parameters command
Class2DDISCmd:		AT+FCC		# disable pre-dial DIS command hack
Class2CIGCmd:		AT+FPI		# set polling identifier command
Class2NRCmd:		AT+FNR=1,1,1,1	# setup status reporting command
Class2PIECmd:		AT+FIE=0	# disable interrupt-enable command
Class2PTSCmd:		AT+FPS		# set post-page status command
Class2SPLCmd:		AT+FSP		# set polling indicator command
Class2NFLOCmd:		AT+FLO=0	# set no flow control command
Class2SFLOCmd:		AT+FLO=1	# set software flow control command
Class2HFLOCmd:		AT+FLO=2	# set hardware flow control command

If by chance you know what to do to make it run with my ELSA 56K (or
which modem 
you can think of) please let me know.
Thanks
-- 
ingo wilmer
geschäftsführung

tel +49 251 98704-22 | jüdefelder str. 37 | http://www.zeitspringer.de 
fax +49 251 98704-11 | 48143 münster	  |