 HylaFAX The world's
most advanced open source fax server
|
[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]
Re: Documentation for hfaxd client-server protocol
- To: Stefano Giro <stefano.giro@msg.it>
- Subject: Re: flexfax: Documentation for hfaxd client-server protocol
- From: Michael Stevens <mstevens@imaginet.co.uk>
- Cc: flexfax@sgi.com
- Date: Tue, 5 Oct 1999 10:55:38 +0100
On Mon, Oct 04, 1999 at 06:31:57PM +0200, Stefano Giro wrote: > I would send fax using directly the hfaxd client server protocol through an ftp access on port 4559.... > Where found good documentation for commands (or one example) JNEW, STOR, STOT, STOU, JNEW, JPARM .... ????? > Then man page of hfaxd is very poor... As far as I'm aware there's very little if any documentation. Unless someone else can say otherwise, you're probably best off reading the source of an existing client.
- Follow-Ups:
- R: Documentation for hfaxd client-server protocol
- From: "Stefano Giro" <stefano.giro@msg.it>
- Re: Documentation for hfaxd client-server protocol
- From: Christoph Scheeder <christoph.scheeder@scheeder.de>
- R: Documentation for hfaxd client-server protocol
- References:
- Documentation for hfaxd client-server protocol
- From: "Stefano Giro" <stefano.giro@msg.it>
- Documentation for hfaxd client-server protocol
- From: "Stefano Giro" <stefano.giro@msg.it>
- Documentation for hfaxd client-server protocol
- Prev by Date: R: Extending sendq deadline time
- Next by Date: 3Com Courier (--> Configuration file for)
- Prev by thread: Documentation for hfaxd client-server protocol
- Next by thread: R: Documentation for hfaxd client-server protocol
- Index(es):
Project hosted by iFAX Solutions