flexfax: Message clarification

[Tim Ballingall <tim@mazda.com.au>]

Hi all,

I was wondering if anyone could tell me a little about this message (
appears when running faxaddmodem ).. I've actually being using Hylafax for a
while so I hope this doesn't seem too dumb..

"Warning, the prototype configuration for your modem uses a different
DTE-DCE communication rate () than the rate that you have selected (38400).
Unless this prototype configuration file is setup to automatically switch
baud rates for facsimile communication, 38400 may not work correctly for
sending and receiving facsimile: check your modem manual to make sure that
38400 is acceptable"

Is the prototype configuration my config.ttyS1 file.....? 

Is the speed being talked about set with "ModemRate:
38400".....? Is 38400 ok...?

Any advice welcome...

Thanks

Tim

Mazda Australia takes every precaution to ensure email messages are virus free. For complete protection, you should virus test this message.