Re: flexfax: waiting for modem to come ready

[Manfred Schtz <mschuetz@via.at>]

Damian Ivereigh wrote:
> 
> Hi Manfred,
> 
> > HylaFAX [..] Server running
> > Modem [ttyS1]: waiting for modem to come ready
> 
> Have you actually tried sending a fax? You might find it actually works
> even though it has this message.
Yes, I tried; it appeared in the message queue, but never got any
further. I received an error message, that it could not be sent [blabla]
> 
> If you don't configure a faxgetty, then faxq just leaves the modem in
> this state expecting faxgetty
> to reset the modem and get it all sorted out and change the status
> message. I agree it is highly misleading.
> 
> Even though you are only using outgoing faxing, it is still highly
> recommended that you still use a faxgetty (Just set your
> "RingsBeforeAnswer:" parameter to zero). Faxgetty is very good at
> resetting tricky modems.
I´m going to try this; however, when I configured a modem on port ttyS0,
the HylaFAX server never even noticed its presence, even after I tried
to disable the modem on port ttyS1.
> 
> Damian
> 
> --
> 
P.S. Since I´m currently not at my office, I use the account of my
husband, so I´m Susan. Didn´t mention that in my first message though -
sorry.
______________________________________________________________________
> * Damian Ivereigh     *      ||        ||      * Cisco Systems, Inc.   *
> * MIS Printer Admin   *    .||||.    .||||.    * Sydney, Australia     *
> * Linux Bigot         * ..:||||||:..:||||||:.. * +61 2 8448 7344       *
> * damian@cisco.com    *   cisco Systems, Inc.  * Fax: +61 2 8448 7228  *
> *______________________________________________________________________*