![]() |
It should work without it. The error message you state below: is that literally what you get? If so then there is something wrong with your config. You have configured the modem to be on "device", rather than say "ttyS1". When you ran faxaddmodem what did you answer to the first question: "Serial port that modem is connected to []?". You should have put in the device name. It is a good idea to run faxgetty as well for a send-only modem, since it performs various resets that are not done otherwise. If so make sure you set RingsBeforeAnswer to 0 in the modem config file (that will stop it actually answering an incoming call). Damian > > Do I need to run faxgetty for send-only modems. I have not done it, I have only > run faxmodem device. When I run faxstate -s ready device and I get: > > FIFO.device: open: No such device or address. > > Faxmodem reports no error, but sending is not done on modems that do not have > faxgetty entries. > > Thanks in advance. > > -- > > Sinisa > > _/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/ > _/ --- ___ \/ - Sinisa Milivojevic, Consultant _/ > _/ -- / o __ o __ ___ - CORES , 11000 Beograd 8-) _/ > _/ - --- / / / / /_ /__/ -- Marsala Tolbuhina 31, SERBIA _/ > _/ ___/ / / / / __/ / / ---- tel:+381 11 4443331,fax: 433001 _/ > _/ ----- http://www.coresinc.com/~sinisa _/ > _/ To defy, to conquer. For us! -- mailto:sinisa@coresinc.com ;o) _/ > _/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/ -- ______________________________________________________________________ * Damian Ivereigh * || || * Cisco Systems, Inc. * * MIS Printer Admin * .||||. .||||. * 408-526-4413 * * Linux Bigot * ..:||||||:..:||||||:.. * 800-800-1180 x64413 * * damian@cisco.com * cisco Systems, Inc. * Fax: 408-527-2563 * *______________________________________________________________________*